SBAU372A April   2021  – November 2025

 

  1.   1
  2.   Description
  3.   Get Started
  4.   Features
  5.   Applications
  6.   6
  7. 1Evaluation Module Overview
    1. 1.1 Introduction
    2. 1.2 Kit Contents
    3. 1.3 Device Information
  8. 2Hardware
    1. 2.1 Required Hardware
    2. 2.2 Hardware Setup
  9. 3Software
    1. 3.1 Required Software
    2. 3.2 Software Setup
  10. 4Setup Procedure
    1. 4.1 Setting up the ADC3543EVM
    2. 4.2 Setting up the ADC3544EVM
  11. 5Hardware Design Files
  12. 6Additional Information
    1. 6.1 Trademarks
  13. 7References

2.2 Hardware Setup

  1. Connect the ADC354xEVM to the TSWDC155EVM using the FMC connectors.
  2. Connect the USB-C connector to J3 on the ADC354xEVM to your PC using the included USB-C Cable.
  3. Connect the USB-C connector to J8 on the TSWDC155EVM to your PC using the included USB C cable.
  4. Connect the Micro USB Cable to the JTAG dongle and connect the JTAG dongle to the JTAG header J7 on the TSWDC155EVM. Then connect the Micro USB Cable to your PC.
  5. Verify that the jumper J2 on the TSWDC155EVM is installed across pins 1-2 to power the board through the USB-C connector.
    ADC3543EVM ADC3544EVM TSWDC155EVM Jumper J2 Figure 2-1 TSWDC155EVM Jumper J2

  6. Verify that the following Switches and Jumpers are in the following configurations on the ADC354xEVM:

    1. Verify that the 12V Power Switch (SW1) is switched to Jack.
    2. Verify that the Comms Mux switch (SW2) is switched to USB.
    3. Verify that the DCLKIN switch (SW3) is switched to SMA.
    4. Verify that the both switches on the VREF CTRL Switch bank (SW5) are switched to ON.
    5. Verify that the VREF Jumper (J11) is populated.
    6. Verify that the PDN/SYNC Jumper (J10) is not connected.
    ADC3543EVM ADC3544EVM ADC354xEVM Switches and JumpersFigure 2-2 ADC354xEVM Switches and Jumpers