SLAAE47A May   2022  – August 2022 DAC11001A , DAC11001B

 

  1.   Abstract
  2.   Trademarks
  3. 1Introduction
  4. 2DAC Error Sources
    1. 2.1 Offset Error
    2. 2.2 Gain Error
    3. 2.3 Integral Non Linearity (INL)
    4. 2.4 Noise Sources
  5. 3Error Sources from Reference
    1. 3.1 Initial Accuracy
    2. 3.2 Temperature Drift
    3. 3.3 Load Regulation Error
    4. 3.4 Line Regulation Error
    5. 3.5 0.1 - 10 Hz Peak-to-Peak Noise
    6. 3.6 Example Using REF7025
  6. 4Error Sources from Inverting and Non-Inverting Gain Stage
    1. 4.1 Input Offset Voltage Error
    2. 4.2 Input Offset Voltage Drift Error
    3. 4.3 Power Supply Rejection Ratio (PSRR) Error
    4. 4.4 Open Loop Gain Error
    5. 4.5 Resistor Tolerance Error
  7. 5Example Calculation using DAC11001A
  8. 6Error Summary
  9. 7References
  10. 8Revision History

1 Introduction

This application report describes how to calculate the total error in a DAC11001 system from various components like reference, reference buffer, output buffer, and the DAC itself. Figure 1-1 shows an example circuit topology using DAC11001 to get a 20 bit linear output. In this example, REF6025 used as reference and OPA828 as output and reference buffer respectively.

Figure 1-1 Circuit Topology
Table 1-1 Design Inputs
Parameters Specifications
Output Voltage ±5 V
Reference source2.5 V
Output TypeBuffered
Resolution20-bit
Operating Temperature Range-40 to 125°C