Table 4-3 Pin Assignment of Target Connector(1)
| Pin |
Signal Name |
Devices With Test Pin |
Pin on MSP430F13x or MSP430F14x |
Pin on MSP430F4xx |
| 1 |
TXD |
P1.1 |
P1.1 |
P1.0 |
| 2 |
TCK |
Do not connect(2) |
TCK |
TCK |
| 3 |
RXD |
P2.2 |
P2.2 |
P1.1 |
| 4 |
RST |
RST/NMI |
RST/NMI |
RST/NMI |
| 5 |
GND |
GND |
GND |
GND |
| 6 |
VCC (3.0 V) |
VCC(3) |
VCC(3) |
VCC(3) |
| 7 |
TST |
TEST |
Do not connect |
Do not connect |
| 8 |
VCC_IN |
VCC(3) |
VCC(3) |
VCC(3) |
| 9 |
Not connected |
— |
— |
— |
| 10 |
Not connected |
— |
— |
— |
(1) For device-specific BSL pin information, see the applicable device data sheet.
(2) Signal TCK must not be connected on devices with the TEST pin.
(3) Pin VCC (3.0 V) is a voltage source that can provide a limited current,
depending on the serial port driver capability. If an external power supply is used, VCC (3.0 V)
must not be connected to the target. In this case, the external supply voltage must be connected to pin
VCC_IN. Otherwise, VCC_IN must be unconnected.