SLVUDO4 November   2026

 

  1.   1
  2.   Description
  3.   Get Started
  4.   Features
  5.   Applications
    1.     6
  6. 1Evaluation Module Overview
    1. 1.1 Introduction
    2. 1.2 Kit Contents
    3. 1.3 Specifications
    4. 1.4 Device Information
  7. 2Hardware
    1. 2.1 Header Information
    2. 2.2 Jumper Information
    3. 2.3 Equipment
    4. 2.4 Hardware Setup
  8. 3Software
    1. 3.1 Software Setup
      1. 3.1.1 EV2400 Setup
      2. 3.1.2 USB2ANY Setup
    2. 3.2 Test Procedure
      1. 3.2.1 Initial Power Up
      2. 3.2.2 I2C Register Communication Verification
      3. 3.2.3 Charger Mode Verification
      4. 3.2.4 Helpful Tips
  9. 4Hardware Design Files
    1. 4.1 Schematic
    2. 4.2 PCB Layout
      1. 4.2.1 PCB Layout Guidelines
    3. 4.3 Bill of Materials (BOM)
  10. 5Additional Information
    1. 5.1 Trademarks

USB2ANY Setup

Use the following steps to set up the EVM testing software:

  1. Start up the TI Charger GUI and select BQ25350 from the charger selection as shown in Figure 3-4.
    Note: If the supplies (VIN or VBAT) are turned off, you need to restart the TI Charger GUI for correct I2C transactions to be reflected in the TI Charger GUI.
    BQ25350EVM TI Charger GUI Device
                            Selection Figure 3-4 TI Charger GUI Device Selection
  2. Use the sidebar to navigate through the different pages to change configurations, see status, flags, and masks, and view the register map. See Figure 3-5 for an example of the Charger Configuration page.
    BQ25350EVM TI Charger GUI
                            Configuration Page Figure 3-5 TI Charger GUI Configuration Page