SLVUDY4 June   2026

 

  1.   1
  2.   Description
  3.   Get Started
  4.   Features
  5.   Applications
  6.   6
  7. 1Evaluation Module Overview
    1. 1.1 Introduction
    2. 1.2 Kit Contents
    3. 1.3 Specification
    4. 1.4 Device Information
  8. 2Hardware
    1. 2.1 Power Requirements
    2. 2.2 Temperature Range
    3. 2.3 Programming, Debug, and Control
      1. 2.3.1 Using a Generic XDS110 Debug Probe, Including a Separate LaunchPad
    4. 2.4 Interfaces
      1. 2.4.1 Debug Interface Connector
      2. 2.4.2 Power Supply Connector
      3. 2.4.3 CAN FD Connector
      4. 2.4.4 UART Connector
      5. 2.4.5 SPI Connector
    5. 2.5 Test Points
  9. 3Advanced Use of the EVM Hardware
    1. 3.1 Radiated/Conducted Testing
  10. 4Software
    1. 4.1 Software Development
  11. 5Hardware Design Files
    1. 5.1 Schematics
    2. 5.2 PCB Layouts
    3. 5.3 Bill of Materials (BOM)
  12. 6Compliance Information
    1. 6.1 CE Compliance
    2. 6.2 REACH Compliance
    3. 6.3 Waste Electrical and Electronic Equipment (WEEE) Compliance
  13. 7Additional Information
    1. 7.1 Known Hardware or Software Issues
    2.     Trademarks
  14. 8References

Test Points

The CC2745R10-CS-EVM has three test points for debug. Table 2-6 shows the test points available on CC2745R10-CS-EVM.

Table 2-6 Test Points
Test Point Name Test Point Description
TP1 DIO19
TP2 DIO20
TP3 GND