SPNU634 January   2020 RM42L432 , RM44L520 , RM44L920 , RM46L430 , RM46L440 , RM46L450 , RM46L830 , RM46L840 , RM46L850 , RM46L852 , RM48L530 , RM48L540 , RM48L730 , RM48L740 , RM48L940 , RM48L950 , RM48L952 , RM57L843 , TMS570LC4357 , TMS570LC4357-EP , TMS570LC4357-SEP , TMS570LS0332 , TMS570LS0432 , TMS570LS0714 , TMS570LS0714-S , TMS570LS0914 , TMS570LS1114 , TMS570LS1115 , TMS570LS1224 , TMS570LS1225 , TMS570LS1227 , TMS570LS2124 , TMS570LS2125 , TMS570LS2134 , TMS570LS2135 , TMS570LS3134 , TMS570LS3135 , TMS570LS3137 , TMS570LS3137-EP

 

  1.   HALCoGen-CSP Without LDRA
    1.     Trademarks
    2. 1 Software Prerequisite
    3. 2 Steps to Install HALCoGen-CSP
    4. 3 Setting up LDRA Unit

3 Setting up LDRA Unit

  1. LDRA UNIT – compiler selection.

    2. Choose Texas Instruments Code Composer v5.0 (Default) (see Figure 2).

    LDRA_choose_TI_CCS_spnu606.gifFigure 2. Compiler Selection
  2. LDRA unit – coverage selection.

    3. Leave it as default (see Figure 3).

    LDRA_coverage_select_spnu606.gifFigure 3. Coverage Selection
  3. LDRA unit – source code browser selection.

    4. Leave it as default or browse to the desired editor.

    LDRA_source_code_select_spnu606.gifFigure 4. Source Code Browser Selection
  4. LDRA unit – choose TI CCS install path.

    5. Default: c:\ti\ccs5\ (see Figure 5).

    Browse to the latest TI CCS installation folder CCS5 or CCS6.

    LDRA_choose_TI_CCS_spnu606.gifFigure 5. Choose TI CCS Install Path
  5. LDRA unit – project configuration (see Figure 6).

    6. Leave it as default to LDRA.

    LDRA_project_config_spnu606.gifFigure 6. Project Configuration
  6. After installation of the LDRA unit and before using HALCoGen TAU, check whethLDRA unit – check LDRA FlexLM server status.

    7. er or not the LDRA FlexLM license server is up and running by doing the following steps.

    NOTE

    The License Configuration Manager must be run as Admin.
    check_LDRA_FlexLM_serv_spnu606.gifFigure 7. Run License Configuration Manager as Admin
    LDRA_license_config_spnu606.gifFigure 8. LDRA License Configuration

    NOTE

    IF you see the FlexLM Server Status as x_spnu606.gif, either the License is expired or the FlexLM service is not started. Restart or start the FlexLM License Service in the Windows as shown in Figure 9.
    restart_start_FlextLM_spnu606.gifFigure 9. Start or Restart FlexLM Server Status