SPRUJ29A April   2022  – January 2023

 

  1.   F2800157 controlCARD Information Guide
  2.   Trademarks
  3. 1Introduction
  4. 2Hardware Quick Setup Guide
    1. 2.1 Configuration 1: Standalone
    2. 2.2 Configuration 2: External 5-V Supply
  5. 3Errata
    1. 3.1 Warnings, Notes, and Errata
    2. 3.2 Warnings About Specific controlCARD Revisions
  6. 4Getting Familiar with the controlCARD
    1. 4.1 F2800157 controlCARD Features
    2. 4.2 Assumed Operating Conditions
      1. 4.2.1 External Power Supply or Accessory Requirements
    3. 4.3 Using the controlCARD
    4. 4.4 Experimentation Software
  7. 5Special Notes
    1. 5.1 XDS110 Emulator and SCI (UART) Connectivity
    2. 5.2 Clocking Methodology
    3. 5.3 Evaluation of the Analog-to-Digital Converters (ADCs)
  8. 6Hardware References
  9. 7Revision History

3.2 Warnings About Specific controlCARD Revisions

Table 3-1 MCU106A
Issue Description
5-V power supply instability can lead to device resets See Section 3.1 about power supply instability.
Table 3-2 MCU106E1
Issue Description
Incorrect label on TP1 TP1 is incorrectly labeled as 5V5 on the front side of the controlCARD PCB. TP1 corresponds to the HSEC_5V0 rail on the board. TP1 can be labeled 5V0.
5-V power supply instability can lead to device resets See Section 3.1 about power supply instability.