Gehäuseinformationen
| Gehäuse | Pins DSBGA (YFF) | 56 |
| Betriebstemperaturbereich (°C) -10 to 85 |
| Gehäusemenge | Träger 3.000 | LARGE T&R |
Merkmale von DLPA2000
- High Efficiency RGB LED/Lamp Driver with Buck-Boost DC-to-DC Converter, DMD Supplies, DPP Core Supply, 1.8-V Load Switch, and Measurement System in a Small Chip-Scale Package
- Three Low-Impedance (30 mΩ Typical at 27°C) MOSFET Switches for Channel Selection
- Independent, 10-Bit Current Control per Channel
- 750-mA Max LED Current for DLPA2000 Embedded Applications
- On-Chip Motor Driver
- DMD
Regulators
- Requires Only a Single Inductor
- VOFS: 10 V
- VBIAS: 18 V
- VRST: –14 V
- Passive Discharge to GND When Disabled
- DPP 1.1-V Core
Supply
- Synchronous Step-Down Converter with Integrated Switching FETs
- Supports up to 600-mA Output Current
- VLED Buck Boost Converter
- Power Save Mode at Light Load Current
- Low-Impedance Load Switch
- VIN Range from 1.8 V to 3.6 V
- Supports up to 200 mA of Current
- Passive Discharge to GND When Disabled
- DMD Reset Signal Generation and Power Supply Sequencing
- 33-MHz Serial Peripheral Interface (SPI)
- Multiplexer for Measuring Analog Signals
- Battery Voltage
- LED Voltage, LED Current
- Light Sensor (for White Point Correction)
- Internal Reference Voltage
- External (Thermistor) Temperature Sensor
- Monitoring and Protection Circuits
- Hot Die Warning and Thermal
- Low-Battery Warning
- Programmable Battery Undervoltage Lockout (UVLO)
- Load Switch UVLO
- Overcurrent and Undervoltage Protection
- DLPA2000 DSBGA Package
- 56-Ball 0.4-mm Pitch
- Die Size: 3.280 mm × 3.484 mm ± 0.03 mm
Beschreibung von DLPA2000
The DLPA2000 is a dedicated PMIC/RGB LED/lamp driver for the DLP2010 and DLP2010NIR digital micromirror devices (DMD) when used with a DLPC3430, DLPC3435, or DLPC150 digital controller. For reliable operation of these chipsets, it is mandatory to use the DLPA2000.