The CC113L is a cost optimized sub-1 GHz RF receiver for the 300–348 MHz, 387–464 MHz, and 779–928 MHz frequency bands. The circuit is based on the popular CC1101 RF transceiver, and RF performance characteristics are identical. The CC115L transmitter together with the CC113L receiver enable a low-cost RF link.
The RF receiver is integrated with a highly configurable baseband demodulator. The modem supports various modulation formats and has a configurable data rate up to 600 kbps.
The CC113L provides extensive hardware support for packet handling, data buffering, and burst transmissions.
The main operating parameters and the 64-byte receive FIFO of CC113L can be controlled through a serial peripheral interface (SPI). In a typical system, the CC113L will be used together with a microcontroller and a few additional passive components.
| 상위 문서 | 유형 | 직함 | 형식 옵션 | 날짜 |
|---|---|---|---|---|
| * | Data sheet | CC113L Value Line Receiver datasheet (Rev. B) | PDF | HTML | 2014/05/08 |
| * | Errata | CC113L Errata Notes | 2011/05/26 | |
| Selection guide | 무선 연결 기술 선택 가이드 (Rev. B) | 2022/03/07 | ||
| Application note | Debugging Communication Range (Rev. A) | PDF | HTML | 2019/05/23 | |
| White paper | Migrating your proprietary solution to the SimpleLink™ WMCU | 2018/11/07 | ||
| Application note | CC-Antenna-DK2 and Antenna Measurements Summary (Rev. A) | 2017/10/02 | ||
| Application note | TI LPRF EASYMODE | 2014/12/12 | ||
| Application note | Antenna Diversity | 2014/10/23 | ||
| Application note | DN038 -- Miniature Helical PCB Antenna for 868 MHz or 915/920 MHz | 2012/11/27 |
추가 조건 또는 필수 리소스는 사용 가능한 경우 아래 제목을 클릭하여 세부 정보 페이지를 확인하세요.
The SmartRF Transceiver Evaluation Board (TrxEB) is intended to be used together with Texas Instruments’ low-power RF transceivers for evaluation, performance testing and software development.
The following transceiver evaluation modules are supported:
SmartRF™ Studio is a Windows application that helps designers of RF systems to easily evaluate the radio at an early stage in the design process for all TI CC1xxx and CC2xxx low-power RF devices. It simplifies generation of the configuration register values and commands, as well as practical (...)
SimpleLink 하드웨어 설계 검토 프로세스는 설계를 검토하고 (...)
| 패키지 | 핀 | CAD 기호, 풋프린트 및 3D 모델 |
|---|---|---|
| VQFN (RGP) | 20 | Ultra Librarian |
권장 제품에는 본 TI 제품과 관련된 매개 변수, 평가 모듈 또는 레퍼런스 디자인이 있을 수 있습니다.
SmartRF Studio 7 in Cloud TI Resource Explorer
Compressed source file archive
SmartRF™ Studio is a Windows application that can be used to evaluate and configure Low Power RF devices from Texas Instruments. The application helps designers of RF systems to easily evaluate the radio at an early stage in the design process. It is especially useful for generation of configuration register values and commands, and for practical testing and debugging of the RF system. SmartRF Studio can be used either as a standalone application or together with applicable evaluation boards or debug probes for the RF device.