首頁 放大器 運算放大器 (op amps) 功率運算放大器
首頁
放大器
運算放大器 (op amps)
功率運算放大器

ALM2402-Q1

現行

具高電流輸出的雙運算放大器

立即訂購
產品規格表

ALM2402-Q1

現行
產品規格表 立即訂購

產品詳細資料

Number of channels 2 Total supply voltage (+5 V = 5, ±5 V = 10) (min) (V) 5 Total supply voltage (+5 V = 5, ±5 V = 10) (max) (V) 16 Iout (typ) (A) 0.75 GBW (typ) (MHz) 0.6 Slew rate (typ) (V/µs) 0.17 Vos (offset voltage at 25°C) (max) (mV) 15 Offset drift (typ) (V/°C) 0.000009 Iq per channel (typ) (mA) 5 Features EMI Hardened, High Cload Drive, Shutdown Rating Automotive Operating temperature range (°C) -40 to 125 TI functional safety category Functional Safety-Capable Input bias current (max) (pA) 100000 CMRR (typ) (dB) 90 Rail-to-rail No Architecture Bipolar
Number of channels 2 Total supply voltage (+5 V = 5, ±5 V = 10) (min) (V) 5 Total supply voltage (+5 V = 5, ±5 V = 10) (max) (V) 16 Iout (typ) (A) 0.75 GBW (typ) (MHz) 0.6 Slew rate (typ) (V/µs) 0.17 Vos (offset voltage at 25°C) (max) (mV) 15 Offset drift (typ) (V/°C) 0.000009 Iq per channel (typ) (mA) 5 Features EMI Hardened, High Cload Drive, Shutdown Rating Automotive Operating temperature range (°C) -40 to 125 TI functional safety category Functional Safety-Capable Input bias current (max) (pA) 100000 CMRR (typ) (dB) 90 Rail-to-rail No Architecture Bipolar
HTSSOP (PWP) 14 32 mm² 5 x 6.4 WSON (DRR) 12 9 mm² 3 x 3
  • High Output Current Drive: 400 mA Continuous (Per Channel)
    • Op-amp With Discrete Power Boost Buffer Replacement
  • Wide Supply Range for Both Supplies (up to 16 V)
  • Over Temperature Shutdown
  • Current Limit
  • Shutdown Pin for Low Iq Applications
  • Stable with Large Capacitive Loads (up to 3 µF)
  • Zero Crossover Distortion
  • Qualified for Automotive Applications
  • AEC-Q100 Qualified With the Following Results:
    • Device Temperature Grade 1: –40°C to 125°C Ambient Operating Temperature Range
    • Device HBM Classification Level H2 (DRR)
    • Device CDM Classification Level C5 (DRR)
  • Low Offset Voltage: 1 mV (typ)
  • Internal RF/EMI Filter
  • Available in 3.00 mm x 3.00 mm 12 Pin WSON (DRR) With Thermal Pad
  • High Output Current Drive: 400 mA Continuous (Per Channel)
    • Op-amp With Discrete Power Boost Buffer Replacement
  • Wide Supply Range for Both Supplies (up to 16 V)
  • Over Temperature Shutdown
  • Current Limit
  • Shutdown Pin for Low Iq Applications
  • Stable with Large Capacitive Loads (up to 3 µF)
  • Zero Crossover Distortion
  • Qualified for Automotive Applications
  • AEC-Q100 Qualified With the Following Results:
    • Device Temperature Grade 1: –40°C to 125°C Ambient Operating Temperature Range
    • Device HBM Classification Level H2 (DRR)
    • Device CDM Classification Level C5 (DRR)
  • Low Offset Voltage: 1 mV (typ)
  • Internal RF/EMI Filter
  • Available in 3.00 mm x 3.00 mm 12 Pin WSON (DRR) With Thermal Pad

The ALM2402-Q1 is a dual high voltage, high current op-amp with protection features that are optimal for driving low impedances and/or high ESR capacitive loads. ALM2402-Q1 operates with single or split power supplies from 5.0 V to 16 V and can output up to 400 mA DC.

Each op-amp includes over-temperature flag/shut-down. It also includes separate supply pins for each output stage that allow the user to apply a lower voltage on the output to limit the Voh and henceforth the on-chip power dissipation.

The ALM2402 is packaged in a 12 pin leadless DRR package and 14 pin leaded HTSSOP (preview). Both include a thermally conductive power pad that facilitates heat sinking. The very low thermal impedance of these packages enable optimal current drive with minimal die temperature increase. Providing customers with the ability to drive high currents in harsh temperature conditions. Maximum power dissipation can be determined in the figure below.

The ALM2402-Q1 is a dual high voltage, high current op-amp with protection features that are optimal for driving low impedances and/or high ESR capacitive loads. ALM2402-Q1 operates with single or split power supplies from 5.0 V to 16 V and can output up to 400 mA DC.

Each op-amp includes over-temperature flag/shut-down. It also includes separate supply pins for each output stage that allow the user to apply a lower voltage on the output to limit the Voh and henceforth the on-chip power dissipation.

The ALM2402 is packaged in a 12 pin leadless DRR package and 14 pin leaded HTSSOP (preview). Both include a thermally conductive power pad that facilitates heat sinking. The very low thermal impedance of these packages enable optimal current drive with minimal die temperature increase. Providing customers with the ability to drive high currents in harsh temperature conditions. Maximum power dissipation can be determined in the figure below.
filter 尋找其它 功率運算放大器
下載 觀看有字幕稿的影片 影片

您可能會感興趣的類似產品

open-in-new 比較替代產品
可直接投入的替代產品，相較於所比較的裝置，具備升級功能
ALM2402F-Q1 現行 雙通道且適用於汽車的高輸出電流運算放大器 This device offers wider bandwidth (2.1 MHz) and higher slew rate (3.4 V/µs)

技術文件

star =TI 所選的此產品重要文件
找不到結果。請清除您的搜尋條件，然後再試一次。
檢視所有 13
類型 標題 日期
* Data sheet ALM2402-Q1 Dual Op-amp with High Current Output datasheet (Rev. D) PDF | HTML 2015年 7月 15日
Functional safety information ALM2402-Q1 Functional Safety, FIT Rate, Failure Mode Distribution and Pin FMA PDF | HTML 2024年 5月 6日
Application brief Full-Featured Automotive Side Mirror PDF | HTML 2024年 3月 15日
Application note Parallel Amplifiers for Higher Output Power: An Improved Howland Pump Approach PDF | HTML 2021年 7月 11日
Application note Overvoltage Protection of Resolver-Based Circuits PDF | HTML 2020年 11月 19日
Technical article Improve efficiency in your HEV/EV resolver PDF | HTML 2019年 11月 27日
E-book Analog Engineer’s Pocket Reference Guide Fifth Edition (Rev. C) 2018年 11月 30日
E-book The Signal e-book: A compendium of blog posts on op amp design topics 2017年 3月 28日
Technical article Using dual high-current op amps to drive automotive LED lights PDF | HTML 2015年 7月 20日
Technical article How a dual operational amplifier works in motor-drive applications PDF | HTML 2015年 6月 3日
Technical article High-current amplifier applications made smaller PDF | HTML 2015年 5月 8日
EVM User's guide ALM2402-Q1 Dual High-Current Amplifier User's Guide 2015年 4月 2日
Application note ALM2402Q1 Applications Note 2015年 4月 1日

設計與開發

如需其他條款或必要資源，請按一下下方的任何標題以檢視詳細頁面 (如有)。

開發板

ALM2402Q1EVM — 雙高電流放大器評估模組

This board is designed for customer evaluation of the ALM2402-Q1 device, specifically the ALM2402QDRRRQ1 orderable part number. The EVM is set up as a basic unity gain amplifier. There are many slots on the board where resistors are not populated; these allow the customer to add filters, custom (...)

使用指南: PDF
TI.com 無法提供
模擬型號

ALM2402-Q1 PSpice Model (Rev. E)

SLOM397E.ZIP (28 KB) - PSpice Model
下載
模擬型號

ALM2402-Q1 TINA-TI Reference Design (Rev. D)

SLOM387D.TSC (368 KB) - TINA-TI Reference Design
下載
模擬型號

ALM2402-Q1 TINA-TI Spice Model (Rev. D)

SLOM386D.ZIP (11 KB) - TINA-TI Spice Model
下載
計算工具

ANALOG-ENGINEER-CALC — 類比工程師計算機

The Analog Engineer’s Calculator is designed to speed up many of the repetitive calculations that analog circuit design engineers use on a regular basis. This PC-based tool provides a graphical interface with a list of various common calculations ranging from setting op-amp gain with feedback (...)
View Options
模擬工具

PSPICE-FOR-TI — PSpice® for TI 設計與模擬工具

PSpice® for TI is a design and simulation environment that helps evaluate functionality of analog circuits. This full-featured, design and simulation suite uses an analog analysis engine from Cadence®. Available at no cost, PSpice for TI includes one of the largest model libraries in the (...)
要求
模擬工具

TINA-TI — 基於 SPICE 的類比模擬程式

TINA-TI provides all the conventional DC, transient and frequency domain analysis of SPICE and much more. TINA has extensive post-processing capability that allows you to format results the way you want them. Virtual instruments allow you to select input waveforms and probe circuit nodes voltages (...)
使用指南: PDF
View Options
封裝 針腳 CAD 符號、佔位空間與 3D 模型
HTSSOP (PWP) 14 Ultra Librarian
WSON (DRR) 12 Ultra Librarian
適用 TI 的評估品項標準條款與條件。

訂購與品質

內含資訊：
  • RoHS
  • REACH
  • 產品標記
  • 鉛塗層/球物料
  • MSL 等級/回焊峰值
  • MTBF/FIT 估算值
  • 材料內容
  • 認證摘要
  • 進行中持續性的可靠性監測
內含資訊：
  • 晶圓廠位置
  • 組裝地點

支援與培訓

內含 TI 工程師技術支援的 TI E2E™ 論壇

以英文檢視所有論壇主題

內容係由 TI 和社群貢獻者依「現狀」提供，且不構成 TI 規範。檢視使用條款。

若有關於品質、封裝或訂購 TI 產品的問題，請參閱 TI 支援。​​​​​​​​​​​​​​

影片