LM3S611 不建議用於新設計
儘管為了支援以前的設計而繼續生產此項產品,但我們並不建議用在新設計上。考量下列其中一項替代產品:
open-in-new 比較替代產品
功能相似於所比較的產品
TM4C123GH6PM 現行 基於 32 位元 Arm Cortex-M4F 的 MCU,具 80 -MHz、256 -KB 快閃記憶體、32 -KB RAM、2 個 CAN、RTC、USB 和 64 接腳 LQFP The product is an ARM® Cortex™-M4 with comparable peripherals and higher performance.
TM4C1294NCPDT 現行 具有 120-MHZ、1-MB 快閃記憶體、256-KB RAM、USB、ENET MAC+PHY 的 32 位元 Arm Cortex-M4F 架構 MCU The product is an ARM® Cortex™-M4 with broader peripherals and higher performance.

產品詳細資料

Flash memory (kByte) 32 Number of GPIOs 32 UART 2 Number of I2Cs 1 Operating temperature range (°C) -40 to 85 PWM (Ch) 6 CAN (#) 0 Rating Catalog
Flash memory (kByte) 32 Number of GPIOs 32 UART 2 Number of I2Cs 1 Operating temperature range (°C) -40 to 85 PWM (Ch) 6 CAN (#) 0 Rating Catalog
LQFP (PT) 48 81 mm² 9 x 9
  • 32-bit ARM® Cortex™-M3 50-MHz processor core with System Timer (SysTick), integrated Nested Vectored Interrupt Controller (NVIC), Memory Protection Unit (MPU), and Thumb-2 instruction set

  • Full-featured debug solution with debug access via JTAG and Serial Wire interfaces, and IEEE 1149.1-1990 compliant Test Access Port (TAP) controller

  • 32 KB single-cycle flash and 8 KB single-cycle SRAM

  • 4-32 GPIOs (depending on configuration) with programmable control for GPIO interrupts and pad configuration

  • ARM FiRM-compliant Watchdog Timer ; plus three General-Purpose Timer Modules (GPTM), each of which provides two 16-bit timers/counters and can be configured to operate independently

  • 10-bit Analog-to-Digital Converter (ADC) with four analog input channels and a sample rate of 500 thousand samples/second

  • Two fully programmable 16C550-type UARTs

  • Synchronous Serial Interface (SSI), supporting operation for Freescale SPI, MICROWIRE, or Texas Instruments synchronous serial interfaces

  • Inter-Integrated Circuit (I2C) Interface, providing Standard (100 Kbps) and Fast (400 Kbps) transmission and support for sending and receiving data as either a master or a slave

  • Three PWM generator blocks, each with one 16-bit counter, two PWM comparators, a PWM signal generator, a dead-band generator, and an interrupt/ADC-trigger selector

  • Industrial and extended temperature RoHS-compliant 48-pin LQFP and 48-pin QFN package

  • 32-bit ARM® Cortex™-M3 50-MHz processor core with System Timer (SysTick), integrated Nested Vectored Interrupt Controller (NVIC), Memory Protection Unit (MPU), and Thumb-2 instruction set

  • Full-featured debug solution with debug access via JTAG and Serial Wire interfaces, and IEEE 1149.1-1990 compliant Test Access Port (TAP) controller

  • 32 KB single-cycle flash and 8 KB single-cycle SRAM

  • 4-32 GPIOs (depending on configuration) with programmable control for GPIO interrupts and pad configuration

  • ARM FiRM-compliant Watchdog Timer ; plus three General-Purpose Timer Modules (GPTM), each of which provides two 16-bit timers/counters and can be configured to operate independently

  • 10-bit Analog-to-Digital Converter (ADC) with four analog input channels and a sample rate of 500 thousand samples/second

  • Two fully programmable 16C550-type UARTs

  • Synchronous Serial Interface (SSI), supporting operation for Freescale SPI, MICROWIRE, or Texas Instruments synchronous serial interfaces

  • Inter-Integrated Circuit (I2C) Interface, providing Standard (100 Kbps) and Fast (400 Kbps) transmission and support for sending and receiving data as either a master or a slave

  • Three PWM generator blocks, each with one 16-bit counter, two PWM comparators, a PWM signal generator, a dead-band generator, and an interrupt/ADC-trigger selector

  • Industrial and extended temperature RoHS-compliant 48-pin LQFP and 48-pin QFN package

The Stellaris® LM3S611 microcontroller is based on the ARM® Cortex™-M3 controller core operating at up to 50 MHz, with 32 kB flash and 8 kB SRAM. The LM3S611 also features real-time industrial connectivity, with an SSI / SPI controller, an I2C interface, and 2 UARTs. The LM3S611 microcontroller also features advanced motion control features, including 6 motion-control PWM outputs with dead-band and 1 fault protection inputs for low-latency shutdown. The microcontroller also features intelligent analog capability, including .4 channels of highly accurate 10-bit analog-to-digital conversion - with the ability to sample at speeds of 500K samples per second. Finally, the LM3S611 microcontroller provides a 24-bit systick timer, 3 32-bit or 6 16-bit general-purpose timers, a watchdog timer, a low drop-out voltage regulator so that only one supply voltage is required, brown-out reset, power-on reset controller, and up to 32 GPIOs.

The Stellaris® LM3S611 microcontroller is based on the ARM® Cortex™-M3 controller core operating at up to 50 MHz, with 32 kB flash and 8 kB SRAM. The LM3S611 also features real-time industrial connectivity, with an SSI / SPI controller, an I2C interface, and 2 UARTs. The LM3S611 microcontroller also features advanced motion control features, including 6 motion-control PWM outputs with dead-band and 1 fault protection inputs for low-latency shutdown. The microcontroller also features intelligent analog capability, including .4 channels of highly accurate 10-bit analog-to-digital conversion - with the ability to sample at speeds of 500K samples per second. Finally, the LM3S611 microcontroller provides a 24-bit systick timer, 3 32-bit or 6 16-bit general-purpose timers, a watchdog timer, a low drop-out voltage regulator so that only one supply voltage is required, brown-out reset, power-on reset controller, and up to 32 GPIOs.

下載 觀看有字幕稿的影片 影片

技術文件

star =TI 所選的此產品重要文件
找不到結果。請清除您的搜尋條件,然後再試一次。
檢視所有 33
類型 標題 日期
* Data sheet Stellaris LM3S611 Microcontroller Data Sheet datasheet (Rev. I) 2014年 7月 15日
* Errata Stellaris LM3S Sandstorm-, Fury-, and DustDevil-Class Microcontrollers Errata 2014年 6月 26日
* Errata ARM Cortex-M3 Errata (r1p0) 2008年 10月 24日
User guide SYS/BIOS (TI-RTOS Kernel) User's Guide (Rev. V) 2020年 6月 1日
User guide TI-RTOS 2.20 User's Guide (Rev. M) 2016年 6月 17日
User guide TI-RTOS 2.16 User's Guide (Rev. L) 2016年 2月 22日
Application note Differences Among Stellaris® LM3S and Tiva™ C Series TM4C123x MCUs (Rev. E) 2013年 9月 24日
User guide Stellaris Boot Loader User's Guide (SW-BOOTLDR-UG) (Rev. P) 2013年 4月 19日
User guide Stellaris Graphics Library User's Guide (SW-GRL-UG) (Rev. P) 2013年 4月 19日
User guide Stellaris Peripheral Driver Library User's Guide (SW-DRL-UG) (Rev. P) 2013年 4月 19日
User guide StellarisWare Release Notes (SW-RLN) (Rev. Q) 2013年 4月 19日
Application note System Design Guidelines for Stellaris® Microcontrollers   (Rev. B) 2013年 2月 4日
Application note ADC Oversampling Techniques for Stellaris Microcontrollers (AN01239) (Rev. A) 2013年 1月 8日
Application note Stellaris® LM3S ADC Calibration (AN01282) (Rev. C) 2012年 11月 1日
Application note Using Execute, Write/Erase Flash Protection on Stellaris MCUs Using CCS (Rev. A) 2012年 8月 15日
User guide StellarisWare Release Notes (SW-RLN) (Rev. N) 2011年 12月 11日
User guide Cortex-M3/M4F Instruction Set Technical User's Manual (Rev. A) 2011年 11月 23日
More literature Stellaris Sandstorm-Class Product Change Notice 2011年 1月 26日
White paper Serial Wire Debug—Ideal for Microcontrollers 2010年 9月 9日
More literature Stellaris Product Change Notice (PCN), Sept 2009 2009年 9月 7日
Application note Clock Fail Detection for Stellaris LM3SX00 MCUs (AN01278) 2009年 7月 7日
Application note Implementing RS-232 Flow Control on a Stellaris Microcontroller (AN01255) 2009年 7月 7日
Application note Optimizing Code Performance and Size for Stellaris Microcontrollers (AN01265) 2009年 7月 7日
Application note Programming the On-Chip Flash Memory in a Stellaris Microcontroller (AN01237) 2009年 7月 7日
Application note Software UART for Stellaris Microcontrollers (AN01270) 2009年 7月 7日
Application note Using Stellaris MCUs Internal Flash Memory to Emulate EEPROM (AN01267) 2009年 7月 7日
Application note Using a 9-bit Software UART with Stellaris (AN01280) 2009年 7月 7日
Application note Using the Stellaris Microcontroller Analog-to-Digital Converter (AN01247) 2009年 7月 7日
Application note Using the Stellaris Serial Flash Loader (AN01242) 2009年 7月 7日
User guide Stellaris Peripheral Driver Library User's Guide (Deprecated Version) 2008年 9月 29日
More literature LM3S611 RevC Product Change Notice (PCN), Dec 2007 2007年 12月 20日
More literature LM3S611 RevC2 Product Change Notice (PCN), May 2007 2007年 12月 4日
More literature LM3S611 RevC0 Product Change Notice (PCN), Oct 2006 2006年 10月 6日

設計與開發

如需其他條款或必要資源,請按一下下方的任何標題以檢視詳細頁面 (如有)。

模擬型號

Stellaris LM3S611 48LQFP BSDL Model (Rev. A)

SPMM024A.ZIP (2 KB) - BSDL Model
模擬型號

Stellaris LM3S611 48LQFP IBIS Model (Rev. A)

SPMM025A.ZIP (251 KB) - IBIS Model
模擬型號

Stellaris LM3S611 48QFN BSDL Model

SPMM478.ZIP (2 KB) - BSDL Model
模擬型號

Stellaris LM3S611 48QFN IBIS Model

SPMM557.ZIP (253 KB) - IBIS Model
封裝 針腳 CAD 符號、佔位空間與 3D 模型
LQFP (PT) 48 Ultra Librarian

訂購與品質

內含資訊:
  • RoHS
  • REACH
  • 產品標記
  • 鉛塗層/球物料
  • MSL 等級/回焊峰值
  • MTBF/FIT 估算值
  • 材料內容
  • 認證摘要
  • 進行中持續性的可靠性監測
內含資訊:
  • 晶圓廠位置
  • 組裝地點

支援與培訓

內含 TI 工程師技術支援的 TI E2E™ 論壇

內容係由 TI 和社群貢獻者依「現狀」提供,且不構成 TI 規範。檢視使用條款

若有關於品質、封裝或訂購 TI 產品的問題,請參閱 TI 支援。​​​​​​​​​​​​​​

影片