首頁 電源管理 高壓側開關和控制器 高壓側開關
首頁
電源管理
高壓側開關和控制器
高壓側開關
最新

TPS1HC120-Q1

現行
立即訂購
產品規格表

TPS1HC120-Q1

現行
產品規格表 立即訂購

產品詳細資料

Number of channels 1 Rating Automotive Operating voltage (max) (V) 28 Operating voltage (min) (V) 3 Ron (typ) (mΩ) 120 Imax (A) 1.5 Current limit (max) (A) 2.1 Current limit (min) (A) 0.2 Current limit type Adjustable FET Internal Features Output Short-Circuit and Overload Protection, Thermal shutdown, UVLO, Under voltage lock out Operating temperature range (°C) -40 to 125 Function Adjustable current limit, Automotive load dump compatibility, Inductive load compatibility, Inrush current control, Short circuit protection, Thermal shutdown
Number of channels 1 Rating Automotive Operating voltage (max) (V) 28 Operating voltage (min) (V) 3 Ron (typ) (mΩ) 120 Imax (A) 1.5 Current limit (max) (A) 2.1 Current limit (min) (A) 0.2 Current limit type Adjustable FET Internal Features Output Short-Circuit and Overload Protection, Thermal shutdown, UVLO, Under voltage lock out Operating temperature range (°C) -40 to 125 Function Adjustable current limit, Automotive load dump compatibility, Inductive load compatibility, Inrush current control, Short circuit protection, Thermal shutdown
SOT-5X3 (DYC) 8 2.52 mm² (2.1 mm × 1.2 mm)
  • Single-channel smart automotive high-side switch with full diagnostics
    • Open-drain status output
    • Current sense analog output (Section 4)
    • ON state open-load detection
  • Wide operating voltage: 3V to 28V
  • Low standby current, < 0.5µA at 85°C
  • Operating junction temperature, –40°C to 150°C
  • Selectable current limit from 0.2A to 2.1A
  • Protection
    • Overload and short-circuit protection
    • Inductive load negative voltage clamp
    • Undervoltage Lockout (UVLO) protection
    • Thermal shutdown and swing with self recovery
    • Loss-of-GND, loss-of-battery, and reverse battery protection
    • Auto-retry on soft-short, latch on hard-short
  • Diagnostic
    • Fault report for fast interrupt
    • On-state output open-load detection
    • Overcurrent and short-to-ground detection
    • Thermal shutdown and swing detection
  • Qualifications
    • AEC-Q100 qualified for automotive:
      • Temperature: –40°C to 125°C, TA
    • Electrical transient disturbance immunity certification of ISO7637-2 and ISO16750-2
  • 8-pin small form factor SOT package
  • Functional Safety Capable
  • Single-channel smart automotive high-side switch with full diagnostics
    • Open-drain status output
    • Current sense analog output (Section 4)
    • ON state open-load detection
  • Wide operating voltage: 3V to 28V
  • Low standby current, < 0.5µA at 85°C
  • Operating junction temperature, –40°C to 150°C
  • Selectable current limit from 0.2A to 2.1A
  • Protection
    • Overload and short-circuit protection
    • Inductive load negative voltage clamp
    • Undervoltage Lockout (UVLO) protection
    • Thermal shutdown and swing with self recovery
    • Loss-of-GND, loss-of-battery, and reverse battery protection
    • Auto-retry on soft-short, latch on hard-short
  • Diagnostic
    • Fault report for fast interrupt
    • On-state output open-load detection
    • Overcurrent and short-to-ground detection
    • Thermal shutdown and swing detection
  • Qualifications
    • AEC-Q100 qualified for automotive:
      • Temperature: –40°C to 125°C, TA
    • Electrical transient disturbance immunity certification of ISO7637-2 and ISO16750-2
  • 8-pin small form factor SOT package
  • Functional Safety Capable

The TPS1HC120-Q1 is a fully protected high-side switch, with integrated NMOS power FET and charge pump, designed to meet the requirements of 12V automotive systems. The low RON (120mΩ typical) minimizes the device power dissipation when driving a wide range of output load current up to 1.5A.

The device integrates protection features such as thermal shutdown, output clamp, and current limit. These features improve system robustness during fault events such as short circuit. The device implements a selectable high-accuracy current limit that improves the reliability of the system by reducing inrush current when driving large capacitive loads. For the D variant, the device also provides an accurate current sense that allows for improved load diagnostics such as overload and open-load detection. Low logic high threshold, VIH, of 1.5V on the input pins allow use of MCUs down to 1.8V.

The TPS1HC120-Q1 can be used to drive a wide variety of resistive, inductive, and capacitive loads, including ADAS cameras, LEDs, relays, solenoids, and heaters. The device is available in a 8-pin, ultra-small form-factor 2.1mm × 1.6mm SOT package with 0.5mm pin pitch, minimizing the PCB footprint.

The TPS1HC120-Q1 is a fully protected high-side switch, with integrated NMOS power FET and charge pump, designed to meet the requirements of 12V automotive systems. The low RON (120mΩ typical) minimizes the device power dissipation when driving a wide range of output load current up to 1.5A.

The device integrates protection features such as thermal shutdown, output clamp, and current limit. These features improve system robustness during fault events such as short circuit. The device implements a selectable high-accuracy current limit that improves the reliability of the system by reducing inrush current when driving large capacitive loads. For the D variant, the device also provides an accurate current sense that allows for improved load diagnostics such as overload and open-load detection. Low logic high threshold, VIH, of 1.5V on the input pins allow use of MCUs down to 1.8V.

The TPS1HC120-Q1 can be used to drive a wide variety of resistive, inductive, and capacitive loads, including ADAS cameras, LEDs, relays, solenoids, and heaters. The device is available in a 8-pin, ultra-small form-factor 2.1mm × 1.6mm SOT package with 0.5mm pin pitch, minimizing the PCB footprint.
filter 尋找其它 高壓側開關
下載 觀看有字幕稿的影片 影片

技術文件

找不到結果。請清除您的搜尋條件，然後再試一次。
檢視所有 4
重要文件 類型 標題 格式選項 下載最新的英文版本 日期
* 資料表 TPS1HC120-Q1, 120mΩ, 1.5A, Single-Channel Automotive Smart High-Side Switch datasheet (Rev. A) PDF | HTML 2026/10/8
功能安全資訊 TPS1HC120-Q1 Functional Safety FIT Rate, FMD and Pin FMA PDF | HTML 2026/9/22
應用說明 Basics of High-Side Switches and Controllers PDF | HTML 2026/3/31
應用說明 How To Drive Resistive, Inductive, Capacitive, and Lighting Loads (Rev. E) PDF | HTML 2021/3/9

設計與開發

如需其他條款或必要資源，請按一下下方的任何標題以檢視詳細頁面 (如有)。

開發板

TPS1HC120Q1EVM — TPS1HC120-Q1 評估模組

TPS1HC120Q1EVM 是硬體評估模組 (EVM)，可用於評估 TPS1HC120-Q1 高壓側開關的功能和性能。TPS1HC120Q1EVM 的設計可做為獨立電路板使用，並具有附加電壓供應和輸出負載。過電流、接地短路、負載開路偵測等功能均已啟用，以供在評估模組上使用。
使用指南: PDF | HTML
支援產品和硬體
有庫存
限制：
??asset.out-of-stock-ti_zh_TW??
無法提供
封裝 針腳 CAD 符號、佔位空間與 3D 模型
SOT-5X3 (DYC) 8 Ultra Librarian
適用 TI 的評估品項標準條款與條件。

訂購與品質

建議產品可能具有與此 TI 產品相關的參數、評估模組或參考設計。

支援與培訓

內含 TI 工程師技術支援的 TI E2E™ 論壇

以英文檢視所有論壇主題

內容係由 TI 和社群貢獻者依「現狀」提供，且不構成 TI 規範。檢視使用條款。

若有關於品質、封裝或訂購 TI 產品的問題，請參閱 TI 支援。​​​​​​​​​​​​​​

影片