首頁 電源管理 DC/DC 切換穩壓器 DC/DC 控制器

TPS40190

現行

4.5-V 至 15-V,20-A 同步降壓控制器

現在提供此產品的更新版本

open-in-new 比較替代產品
功能相似於所比較的產品。
TPS548B28 現行 具有遠端感測和打嗝電流限制的 2.7-V 至 16-V 輸入、20-A 同步降壓轉換器 Upgraded light-load efficiency, low IQ and extended positive operating temperature.

產品詳細資料

Rating Catalog Topology Buck Iout (max) (A) 20 Vin (max) (V) 15 Vin (min) (V) 4.5 Vout (max) (V) 12.75 Vout (min) (V) 0.6 Control mode Voltage mode Features Enable, Pre-Bias Start-Up, Synchronous Rectification Duty cycle (max) (%) 85 Iq (typ) (A) 0.0025 Number of phases 1 Operating temperature range (°C) -40 to 85
Rating Catalog Topology Buck Iout (max) (A) 20 Vin (max) (V) 15 Vin (min) (V) 4.5 Vout (max) (V) 12.75 Vout (min) (V) 0.6 Control mode Voltage mode Features Enable, Pre-Bias Start-Up, Synchronous Rectification Duty cycle (max) (%) 85 Iq (typ) (A) 0.0025 Number of phases 1 Operating temperature range (°C) -40 to 85
VSON (DRC) 10 9 mm² (3 mm × 3 mm)
  • Input Operating Voltage Range: 4.5 V to 15 V
  • Reference 0.591 V ±1%
  • Voltage Mode Control
  • Internal 5-V Regulator For Internal Housekeeping, Driver Power and Light External Loads
  • Selectable Short-Circuit Protection Thresholds
  • Pre-Bias Ouput Safe
  • Fixed Switching Frequency of 300 kHz
  • Internal Soft Start
  • Small 3 mm × 3 mm, 10-Pin SON Package
  • Bootstrapped Drivers for N-Channel MOSFET
  • Adaptive Anti-Cross Conduction
  • Internal Bootstrap Diode
  • 1.2-A Drivers for Decreased Switching Loss
  • Input Operating Voltage Range: 4.5 V to 15 V
  • Reference 0.591 V ±1%
  • Voltage Mode Control
  • Internal 5-V Regulator For Internal Housekeeping, Driver Power and Light External Loads
  • Selectable Short-Circuit Protection Thresholds
  • Pre-Bias Ouput Safe
  • Fixed Switching Frequency of 300 kHz
  • Internal Soft Start
  • Small 3 mm × 3 mm, 10-Pin SON Package
  • Bootstrapped Drivers for N-Channel MOSFET
  • Adaptive Anti-Cross Conduction
  • Internal Bootstrap Diode
  • 1.2-A Drivers for Decreased Switching Loss

The TPS40190 is a cost-optimized synchronous buck controller that operates from 4.5 V to 15 V nominally, and implements a fixed frequency voltage mode power supply. The controller uses an adaptive anti-cross conduction scheme to prevent both the high-side and the rectifier MOSFET to be turned on at the same time, preventing shoot through current in the two MOSFETs.

The controller also provides a short circuit protection threshold that is user selectable between one of three values. The protection level is set with a single external resistor connected from COMP to GND. During start-up, the impedance connected to COMP is sensed, and the information is decoded to select one of the three thresholds. When the controller senses an output short circuit, both MOSFETs are turned off and a timeout period is observed before attempting to restart. This provides limited power dissipation in the event of a sustained fault.

The TPS40190 provides strong drivers to minimize switching losses in the power stage, reducing heat build up in the MOSFETs and allowing larger MOSFETs to be used without undue switching time penalty.

The TPS40190 is a cost-optimized synchronous buck controller that operates from 4.5 V to 15 V nominally, and implements a fixed frequency voltage mode power supply. The controller uses an adaptive anti-cross conduction scheme to prevent both the high-side and the rectifier MOSFET to be turned on at the same time, preventing shoot through current in the two MOSFETs.

The controller also provides a short circuit protection threshold that is user selectable between one of three values. The protection level is set with a single external resistor connected from COMP to GND. During start-up, the impedance connected to COMP is sensed, and the information is decoded to select one of the three thresholds. When the controller senses an output short circuit, both MOSFETs are turned off and a timeout period is observed before attempting to restart. This provides limited power dissipation in the event of a sustained fault.

The TPS40190 provides strong drivers to minimize switching losses in the power stage, reducing heat build up in the MOSFETs and allowing larger MOSFETs to be used without undue switching time penalty.

下載 觀看有字幕稿的影片 影片

技術文件

找不到結果。請清除您的搜尋條件,然後再試一次。
檢視所有 5
重要文件 類型 標題 格式選項 下載最新的英文版本 日期
* 資料表 TPS40190 4.5-V to 15-V Input, Voltage-Mode, Synchronous Buck Controller datasheet (Rev. D) PDF | HTML 2019/6/6
使用指南 TPS40190 Buck Controller Evaluation Module User's Guide (Rev. A) PDF | HTML 2022/1/10
選擇指南 Power Management Guide 2018 (Rev. R) 2018/6/25
應用說明 Enabling Multiple TPS4019x Devices 2012/3/29
更多文件說明 TPS40190DRC Test Report 2008/2/15

設計與開發

如需其他條款或必要資源,請按一下下方的任何標題以檢視詳細頁面 (如有)。

模擬型號

TPS40190 TINA-TI Average Reference Design (Rev. C)

SLVC180B (112 KB) - TINA-TI 參考設計
支援產品和硬體
模擬型號

TPS40190 TINA-TI Average Spice Model (Rev. A)

SLVM015 (3 KB) - TINA-TI Spice 模型
支援產品和硬體
模擬型號

TPS40190 TINA-TI Transient Reference Design (Rev. B)

SLVM014 (150 KB) - TINA-TI 參考設計
支援產品和硬體
模擬型號

TPS40190 TINA-TI Transient Spice Model (Rev. B)

SLVM016 (18 KB) - TINA-TI Spice 模型
支援產品和硬體
模擬型號

TPS40190 Unencrypted PSpice Average Model Package (Rev. A)

SLUM371A.ZIP (17 KB) - PSpice 模型
支援產品和硬體
模擬型號

TPS40190 Unencrypted PSpice Transient Model Package (Rev. D)

SLVC179D.ZIP (40 KB) - PSpice 模型
支援產品和硬體
計算工具

SLUC263 — Type III Compensation Calculation Tool

支援產品和硬體
封裝 針腳 CAD 符號、佔位空間與 3D 模型
VSON (DRC) 10 Ultra Librarian

訂購與品質

建議產品可能具有與此 TI 產品相關的參數、評估模組或參考設計。

支援與培訓

內含 TI 工程師技術支援的 TI E2E™ 論壇

內容係由 TI 和社群貢獻者依「現狀」提供,且不構成 TI 規範。檢視使用條款

若有關於品質、封裝或訂購 TI 產品的問題,請參閱 TI 支援。​​​​​​​​​​​​​​

影片