計算工具
產品規格表
TPS63002
- Input Voltage Range: 1.8 V to 5.5 V
- Fixed and Adjustable Output Voltage Options from 1.2 V to 5.5 V
- Up to 96% Efficiency
- 1200-mA Output Current at 3.3 V in Step-Down Mode (VIN = 3.6 V to 5.5 V)
- Up to 800-mA Output Current at 3.3 V in Boost Mode (VIN > 2.4 V)
- Automatic Transition Between Step-Down and Boost Mode
- Device Quiescent Current less than 50 μA
- Power-Save Mode for Improved Efficiency at Low Output Power
- Forced Fixed Frequency Operation and Synchronization Possible
- Load Disconnect During Shutdown
- Overtemperature Protection
- Available in a Small 3-mm × 3-mm 10-Pin VSON Package (QFN)
All trademarks are the property of their respective owners.
The TPS6300x devices provide a power supply solution for products powered by either a two-cell or three-cell alkaline, NiCd or NiMH battery, or a one-cell Li-ion or Li-polymer battery. Output currents can go as high as 1200 mA while using a single-cell Li-ion or Li-polymer battery, and discharge it down to 2.5 V or lower. The buck-boost converter is based on a fixed frequency, pulse width modulation (PWM) controller using synchronous rectification to obtain maximum efficiency. At low load currents, the converter enters power-save mode to maintain high efficiency over a wide load current range. The power-save mode can be disabled, forcing the converter to operate at a fixed switching frequency. The maximum average current in the switches is limited to a typical value of 1800 mA. The output voltage is programmable using an external resistor divider, or is fixed internally on the chip. The converter can be disabled to minimize battery drain. During shutdown, the load is disconnected from the battery.
The TPS6300x devices operate over a free air temperature range of –40°C to 85°C. The devices are packaged in a 10-pin VSON package (QFN) measuring 3 mm × 3 mm (DRC).
技術文件
找不到結果。請清除您的搜尋條件，然後再試一次。
檢視所有 9 | 類型 | 標題 | 日期 | ||
|---|---|---|---|---|
| * | Data sheet | TPS6300x High-Efficient Single Inductor Buck-Boost Converter With 1.8-A Switches datasheet (Rev. C) | PDF | HTML | 2015年 10月 30日 |
| Application note | QFN and SON PCB Attachment (Rev. C) | PDF | HTML | 2023年 12月 6日 | |
| Application note | Layer Design for Reducing Radiated EMI of DC to DC Buck-Boost Converters (Rev. A) | PDF | HTML | 2021年 6月 9日 | |
| Application note | Performing Accurate PFM Mode Efficiency Measurements (Rev. A) | 2018年 12月 11日 | ||
| Application note | Understanding Undervoltage Lockout in Power Devices (Rev. A) | 2018年 9月 19日 | ||
| Application note | Basic Calculations of a 4 Switch Buck-Boost Power Stage (Rev. B) | 2018年 7月 9日 | ||
| Selection guide | Power Management Guide 2018 (Rev. R) | 2018年 6月 25日 | ||
| Analog Design Journal | IQ: What it is, what it isn’t, and how to use it | 2011年 6月 17日 | ||
| Application note | Minimizing Ringing at the Switch Node of a Boost Converter | 2006年 9月 15日 |
設計與開發
如需其他條款或必要資源，請按一下下方的任何標題以檢視詳細頁面 (如有)。
開發板
TPS63000EVM-148 — TPS63000 5.5V 輸入、3.3V 輸出、1A 降壓-升壓轉換器評估模組基板
Evaluation Module Board for Buck-Boost Converter 5.5V Input, 3.3V Output, 1A
The TPS63000EVM-148 is an evaluation tool for the TPS63000 device family. It is a 96% efficient Buck/Boost Converter with an input range of 1.8 V to 5.5 V, optimized to run from a single-cell Li-Ion battery (...)
使用指南: PDF
模擬型號
TPS63002 Unencrypted PSpice Transient Model Package (Rev. A)
SLIM106A.ZIP (38 KB) - PSpice Model
參考設計
TIDM-ORIENTATIONTRACKER — 低功耗方向追蹤器參考設計
This reference application demonstrates how to combine an ultra-low-power MSP microcontroller, fixed-point software math libraries and an accelerometer for a low cost, ultra-low-power, simple orientation tracking solution. The MSP MCU samples the accelerometer and performs calculations in real time (...)
| 封裝 | 引腳 | 下載 |
|---|---|---|
| VSON (DRC) | 10 | 檢視選項 |
訂購與品質
內含資訊：
- RoHS
- REACH
- 產品標記
- 鉛塗層/球物料
- MSL 等級/回焊峰值
- MTBF/FIT 估算值
- 材料內容
- 資格摘要
- 進行中可靠性監測
內含資訊：
- 晶圓廠位置
- 組裝地點