TPS61325 1.5A/4.1A Multiple LED Camera Flash Driver with I2C Compatible Interface |


1.5A/4.1A Multiple LED Camera Flash Driver with I2C Compatible Interface



The TPS6132x device is based on a high-frequency synchronous boost topology with constant current sinks to drive up to three white LEDs in parallel (445-mA, 890-mA, 445-mA maximum flash current). The extended high-current mode (HC_SEL) allows up to 1025-mA, 2050-mA, and 1025-mA flash current out of the storage capacitor.

The high-capacity storage capacitor on the output of the boost regulator provides the high-peak flash LED current, thereby reducing the peak current demand from the battery to a minimum.

The 2-MHz switching frequency allows the use of small and low profile 2.2-μH inductors. To optimize overall efficiency, the device operates with a 400-mV LED feedback voltage.

The TPS6132x device not only operates as a regulated current source, but also as a standard voltage boost regulator. The device keeps the output voltage regulated even when the input voltage exceeds the nominal output voltage. The device enters power-save mode operation at light load currents to maintain high efficiency over the entire load current range.

To simplify DC-light and flashlight synchronization with the camera module, the device offers a dedicated control interface (STRB0 and STRB1 pins) for zero latency LED turnon time.


  • Four Operational Modes
    • DC-Light and Flashlight
    • Voltage Regulated Converter: 3.8 V to 5.7 V
    • Standby: 2 μA (Typical)
  • Storage Capacitor Friendly Solution
  • Automatic VF and ESR Calibration
  • Power-Save Mode for Improved Efficiency at Low Output Power, Up to 95% Efficiency
  • Output Voltage Remains Regulated When Input Voltage Exceeds Nominal Output Voltage
  • I2C Compatible Interface up to 3.4 Mbps
  • Dual Wire Camera Module Interface
  • Zero Latency Tx-Masking Input
  • LED Temperature Monitoring
  • Privacy Indicator LED Output
  • Integrated LED Safety Timer
  • GPIO/Flash Ready Output
  • Total Solution Size of Less Than 25 mm2 (< 1-mm height)
  • Available in a 20-Pin NanoFree (DSBGA)

All trademarks are the property of their respective owners.

View more

Parametrics Compare all products in Flash LED drivers

Vin (Min) (V)
Vin (Max) (V)
LED (#)
Iout (Max) (A)
Iq (Typ) (mA)
Operating temperature range (C)
Package Group
Package size: mm2:W x L (PKG)
TPS61325 TPS61050 TPS61052 TPS61310 TPS61311
2.5     2.5     2.5     2.5     2.5    
5.5     6     6     5.5     5.5    
3     1     1     3     3    
1.5     1.2     1.2     1.5     1.5    
0.59     8.5     8.5     0.59     0.59    
I2C Control     Load Disconnect During Shutdown     Load Disconnect During Shutdown     I2C Control     Over Current Protection
Synchronous Rectification    
-40 to 85     -40 to 85     -40 to 85     -40 to 85     -40 to 85    
DSBGA | 20     DSBGA | 12
VSON | 10    
DSBGA | 12
VSON | 10    
DSBGA | 20     DSBGA | 20    
See datasheet (DSBGA)     See datasheet (DSBGA)
10VSON: 9 mm2: 3 x 3 (VSON | 10)    
See datasheet (DSBGA)
10VSON: 9 mm2: 3 x 3 (VSON | 10)    
See datasheet (DSBGA)     See datasheet (DSBGA)