7.5.3 General Programming Requirements
Follow these requirements when programming the device:
- For register bits that do not have field names in Table 24, it is necessary to program these values just as shown in the register map.
- Not all registers need to be programmed. Refer to Table 23 for details.
- Power-on-reset register values may not be optimal, so it is always necessary to program all of the required registers after powering on the device. Note that the 'Reset' column in register descriptions is the power-on-reset value.
Table 23. Programming Requirement
|R107 – R112
||These registers are for readback only and do not need to be programmed.
|R79 – R106
||If ramping function is not used (RAMP_EN = 0), then these registers do not need to be programmed.
|R0 – R78
||These registers need to be programmed for all scenarios.