SLVUBX4A November   2020  – February 2022 LP8764-Q1


  1.   Trademarks
  2. 1Introduction
  3. 2Getting Started
    1. 2.1 Getting Started: Single EVM
    2. 2.2 Getting Started: Multiple EVM Evaluation
    3. 2.3 GUI Tool
  4. 3EVM Details
    1. 3.1 Terminal Blocks
    2. 3.2 Test Point Descriptions
    3. 3.3 Configuration Headers
    4. 3.4 Stack-up Headers
    5. 3.5 Connectors
    6. 3.6 Dip Switches
    7. 3.7 EVM Control and GPIO
  5. 4Customization
    1. 4.1 Changing the Communication Interface
    2. 4.2 Changing the Phase Configuration
  6. 5Schematic, Layout, and Bill of Materials
  7. 6Additional Resources
  8. 7Revision History

EVM Details

The following sections describe the various interfaces for measuring and controlling the configuration. Note: the configurations are in coordination with the settings of the PMIC. It is important to understand that both the EVM configuration and the settings of the PMIC must match. For example, if the GUI is used to change the PMIC interface to SPI from I2C, then the appropriate SPI related jumpers should be in place on J20 and J25. Please refer to the GUI User's Guide SLVUBT8 on how to update the PMIC communication protocol.