SDAA281 July   2026 BQ34Z100-R2

 

  1.   1
  2.   Abstract
  3.   Trademarks
  4. 1 Introduction
  5. 2 Minimum Parameters
    1. 2.1  Design Capacity
    2. 2.2  Design Voltage
    3. 2.3  Design Energy
    4. 2.4  Load Mode
    5. 2.5  Load Select
    6. 2.6  Cell Charging Voltage TX-TY
    7. 2.7  Number of Series Cell
    8. 2.8  Flash Update OK Cell Voltage
    9. 2.9  Cell Terminate Voltage
    10. 2.10 Taper Current
    11. 2.11 DSG Current Threshold
    12. 2.12 CHG Current Threshold
    13. 2.13 Quit Current Threshold
    14. 2.14 ChemID
  6. 3 Learning Cycle
  7. 4 Calibration
    1. 4.1 Current Calibration
    2. 4.2 Voltage Calibration and Voltage Divider
    3. 4.3 CC Offset Routine
  8. 5 Scaling
  9. 6 Additional Key Parameters and Features
    1. 6.1 OCV Wait Time
    2. 6.2 SOH Load I
    3. 6.3 Voltage Divider Parameter
    4. 6.4 RA Table Limiters
    5. 6.5 T Rise and T Time Constant
    6. 6.6 Auto Calibration
    7. 6.7 Smoothing
    8. 6.8 Sealed SRECs
  10. 7 Hardware
    1. 7.1 VEN Pin
    2. 7.2 Thermistor
    3. 7.3 Sense Resistor
    4. 7.4 Voltage Divider Calculation
    5. 7.5 LEDs
  11. 8 Chemistries
    1. 8.1 LFP
    2. 8.2 NiMH/NiCd
  12. 9 Debugging
  13. 10G1
  14. 11Reference Design
  15. 12Summary
  16. 13References

2.4 Load Mode

Load Mode tells the gauge to use either a constant current model or a constant power model for IT simulations. For true constant power loads use constant power mode, for all other applications use constant current mode.

Load mode = 0, Constant Current Model

Load mode = 1, Constant Power Model