9 Revision History
Changes from Revision C (February 1997) to Revision D (January 2025)
- Deleted "On chip offset voltage
trimming for improved DC performance"Go
- Deleted "Direct upgrades to TL05x, TL07x, and TL08x Operational
Amplifiers"Go
- Changed Low bias current from ±1pA to ±15pAGo
- Removed Total current in and out of VCCGo
- Changed Supply voltage valuesGo
- Changed Common mode input voltage input rangeGo
- Changed minimum from –19V to 0VGo
- Changed Maximum Positive peak output voltage swing typical value
from 4.1V to 4.985V.Go
- Changed Maximum Positive peak output voltage swing typical value
from 3.9V to 4.925V.Go
- Changed Maximum Positive peak output voltage swing typical value
from 2.3V to 4.5V.Go
- Deleted Full range values in IOS CMRR.Go
- Changed Maximum negative peak output voltage swing typical value
from -4.2V to -4.985V.Go
- Changed Maximum negative peak output voltage swing typical value
from -4.1V to -4.925V.Go
- Changed Maximum negative peak output voltage swing typical value
from −2.4V to −4.5V.Go
- Deleted Full range values in AVD.Go
- Changed Input resistance separated for differential and common mode,
values to 100MΩ and 6TΩ.Go
- Changed Input capacitance from 11pF to 1pF, 2.9pF to
9pF.Go
- Changed CMRR typical value from 89dB to 85dB.Go
- Changed Supply current values from 1.6mA to 2.48mA and 2.2mA to
2.92mA.Go
- Changed Short circuit output current values from −35mA to
±65mA.Go
- Changed Slew rate typical values from 35V/μs to 32V/μs in EC table
of specifications. Go
- Merged positive and negative slew rates in EC table of
specifications. Go
- Deleted maximum value for Equivalent input noise voltage and at
10Khz typical value updated from 12nV/√Hz to 4.4nV/√Hz in EC table of
specifications.Go
- Changed Peak to peak equivalent input noise voltage, from
0.6μVPP to 2.77μVPP in EC table of
specifications.Go
- Changed Equivalent input noise current from 2.8fA/√Hz to 60fA/√Hz at
1KHz in EC table of specifications.Go
- Changed THD+N value from 0.013% to 0.0032% and 90dB in EC table of
specifications.Go
- Changed Unity gain bandwidth values from 9.4MHz to 10.6MHz in EC
table of specifications.Go
- Changed Maximum output swing bandwidth from 2.8Mhz to 300KHz in EC
table of specifications.Go
- Changed VOM+ values from 14.1V to 14.985V at 200μA from
13.9V to 14.925V at 2mA, from 12.3V to 14.5V at 20mA.Go
- Changed VOM- valued from –14.2V to –14.985V at 200μA
from –14V to –14.925V at 2mA, from -12.4V to -14.5V at 20mA.Go
- Deleted Full range for CMRR.Go
- Changed Input capacitance Differential mode from 2.5pF to
9pFGo
- Changed Input capacitance Common mode from 7.5pF to
1pFGo
- Changed Supply current typical from 1.7mA to 2.48mAGo
- Changed Supply current maximum from 2.2mA to 2.92mAGo
- Changed Short-circuit output current typical value to
±65mAGo
- Updated Phase Margin vs Load Capacitance plotGo
- Updated Non-inverting Large-Signal Pulse Response
plotGo
- Updated Small-Signal Pulse Response plotGo
- Updated Open-Loop Output Impedance vs Frequency
plotGo
- Removed several plots from Typical Characteristics
section.Go