SLVUDL1A November   2025  – December 2025

1.   1
2.   Description
3.   Features
4.   Applications
5.   5
6. 1Evaluation Module Overview
   1. 1.1 Introduction
   2. 1.2 Kit Contents
   3. 1.3 Specification
   4. 1.4 Device Information
   5. 1.5 General Texas Instruments High Voltage Evaluation (TI HV EVM) User Safety Guidelines
7. 2Hardware
   1. 2.1 Test Points
      1. 2.1.1 Key Connections
         1. 2.1.1.1 Connect a Supply to J3 Connector
         2. 2.1.1.2 PWM Input
            1. 2.1.1.2.1 IIM Mode using on board dead time generation circuit (Single PWM Input)-Default Mode
            2. 2.1.1.2.2 IIM Mode using two separate PWM inputs (Dual PWM Input)
            3. 2.1.1.2.3 PWM Input Mode (Single PWM Input)
         3. 2.1.1.3 Resistor controls
            1. 2.1.1.3.1 Slew-rate control resistors
            2. 2.1.1.3.2 Dead-time control resistors
         4. 2.1.1.4 Power Supply
   2. 2.2 Power-Up Procedure
      1. 2.2.1 Step 1: Driver Bias Supply
      2. 2.2.2 Step 2: Input Supply
      3. 2.2.3 Step 3: Measure SW Voltage
      4. 2.2.4 Setting Dead-Time
   3. 2.3 Power- Down Procedure
   4. 2.4 Zero Voltage Detection (ZVD) Reporting
   5. 2.5 Ideal Diode Mode
   6. 2.6 Fault Detection
   7. 2.7 Assembly Guidelines
8. 3Implementation Results
   1. 3.1 Electrical Performance Specifications
      1. 3.1.1 Evaluation Setup
   2. 3.2 Performance Data and Results
      1. 3.2.1 Efficiency results
9. 4Hardware Design Files
   1. 4.1 Schematics
   2. 4.2 PCB Layouts
   3. 4.3 Bill of Materials (BOM)
10. 5Additional Information
    1.     Trademarks
11. 6Revision History