TIDUEZ9B July   2022  – April 2023

 

  1.   Description
  2.   Resources
  3.   Features
  4.   Applications
  5.   5
  6. 1System Description
    1. 1.1 Isolated Current Measurement
    2. 1.2 Band-Pass Filter
    3. 1.3 Analog-to-Digital Conversion
    4. 1.4 Arc Detection Algorithm
    5. 1.5 Key System Specifications
  7. 2System Overview
    1. 2.1 Block Diagram
    2. 2.2 Design Considerations
      1. 2.2.1 Current Transformer Circuit
      2. 2.2.2 Analog Band-Pass Filter
      3. 2.2.3 Analog-to-Digital Conversion
      4. 2.2.4 Power Supply
      5. 2.2.5 Debugging and Status Indication Options
    3. 2.3 Highlighted Products
      1. 2.3.1 TPS259474
      2. 2.3.2 TPS562202
      3. 2.3.3 TPS745
      4. 2.3.4 OPAx322
      5. 2.3.5 ADS8363
      6. 2.3.6 REF5025
      7. 2.3.7 TMDSCNCD280049C
  8. 3Hardware, Software, Testing Requirements, and Test Results
    1. 3.1 Hardware and Software Requirements
      1. 3.1.1 Hardware
      2. 3.1.2 Software
        1. 3.1.2.1 Arc Detection Theory
        2. 3.1.2.2 Software Implementation
    2. 3.2 Test Setup
      1. 3.2.1 ControlCARD Configuration
      2. 3.2.2 Setup for Hardware and Software Validation
      3. 3.2.3 Setup for Arc Testing
    3. 3.3 Test Results
      1. 3.3.1 Test Results of Hardware and Software Validation
      2. 3.3.2 Testing With Arcs
  9. 4Design and Documentation Support
    1. 4.1 Design Files
      1. 4.1.1 Schematics
      2. 4.1.2 BOM
    2. 4.2 Tools and Software
    3. 4.3 Support Resources
    4. 4.4 Trademarks
  10. 5About the Author
  11. 6Revision History

1.2 Band-Pass Filter

To limit the spectrum of the acquired signal, a band-pass filter is implemented. Since a solar inverter system can be a noisy environment, a 4th order low-pass filter and a 4th order high-pass filter is selected. The separate structure is chosen, to easily adjust upper and lower boundaries of the frequency range. Design this filter in a way to filter out the switching frequency as well other noise sources. In this design a frequency band of 30 kHz to 100 kHz is selected, but the frequency band must specifically be adjusted for each application.