NUEVO

AWRL6888

PRESENTACIÓN PRELIMINAR

Sensor de radar de ondas milimétricas automotriz de 57 GHz a 64 GHz de alto rendimiento, baja potenc

Haga su pedido ahora

Hoja de datos

document-pdfAcrobat AWRL6888 Single-Chip 57 to 64GHz Automotive Radar Sensor datasheet (Inglés) PDF | HTML

AWRL6888

PRESENTACIÓN PRELIMINAR

Hoja de datos

Haga su pedido ahora

Detalles del producto

Frequency range

57 - 64 GHz

Number of receivers

8

Number of transmitters

8

ADC sampling rate (max) (Msps)

12.5

Arm CPU

Arm Cortex-R5F at 200MHz

Interface type

2 CAN-FD, GPIO, I2C, LIN, PWM, QSPI, SPI, UART

DSP type

C66x DSP 450MHz

Hardware accelerators

Radar hardware accelerator

RAM (kByte)

2500

Rating

Automotive

Operating temperature range (°C)

to

TI functional safety category

Functional Safety-Compliant

Security

Cryptographic acceleration, Device attestation & anti-counterfeit, Secure boot, Secure firmware & software update, Secure storage, Software IP protection

Power supply solution

TPS650365-Q1

Frequency range

57 - 64 GHz

Number of receivers

8

Number of transmitters

8

ADC sampling rate (max) (Msps)

12.5

Arm CPU

Arm Cortex-R5F at 200MHz

Interface type

2 CAN-FD, GPIO, I2C, LIN, PWM, QSPI, SPI, UART

DSP type

C66x DSP 450MHz

Hardware accelerators

Radar hardware accelerator

RAM (kByte)

2500

Rating

Automotive

Operating temperature range (°C)

to

TI functional safety category

Functional Safety-Compliant

Security

Cryptographic acceleration, Device attestation & anti-counterfeit, Secure boot, Secure firmware & software update, Secure storage, Software IP protection

Power supply solution

TPS650365-Q1

FCCSP (APD)

329

121 mm² (11 mm × 11 mm)

FMCW Transceiver
- Integrated PLL, transmitter, receiver, baseband and ADC
- 57 - 64GHz coverage With 7 GHz continuous bandwidth
- 8 receive channels with 2:1 switching and 8 transmit channels
- 9 dBm typical output power per Tx
- 12.5 dB Typical noise figure
- -90.5 dBc/Hz typical phase noise at 1MHz
- FMCW operation
- 10 MHz IF bandwidth, real-only Rx channels
- Ultra-accurate chirp engine based on fractional-N PLL
- One binary phase shifter per transmit channel pair
Processing elements
- Arm R5F core with double precision FPU (200 MHz)
- Hardware Accelerator (HWA 1.2) for FFT, log magnitude, and CFAR operations (200 MHz)
- C66x DSP (450MHz) for post processing Radar data
Supports multiple low-power modes
- Idle mode and deep sleep mode
Power management
- 1.8-V and 3.3-V IO support
- Built-in LDO network for enhanced PSRR
- Two power rails for 1.8-V IO mode, Three power rails for 3.3-V IO mode

FCCSP package having 21 x 21 BGA grid, 329 BGA balls, Package size : 11mm x 11mm
Built-in calibration and self-test
- Built-in Firmware (ROM)
- Self-Contained on chip calibration system
Host Interface
- 3 x UART
- 2 x CAN-FD
- 2 x SPI
- 1 x LIN
LVDS for data transfer of raw ADC sample capture
Other interfaces available to user application
- QSPI
- I2C
- JTAG
- 8 x GPIOs
- PWM Interface
- 4 x GPADCs
Device security (applicable to secure device variants)
- Programmable embedded hardware security module (HSM)
- Secure authenticated and encrypted boot support
- Customer programmable root keys, symmetric keys (256 bit), asymmetric keys (up to RSA-4K or ECC-512) with key revocation capability
- Cryptographic hardware accelerators: PKA with ECC/RSA, AES (up to 256 bit), SHA (up to 512 bit), TRNG/DRBG and SM2,SM3,SM4(Chinese Crypto Algorithms)
- Product Cybersecurity Compliance
  - ISO21434 compliant up to CAL2 targeted
  - Developed for cybersecurity-relevant applications
  - Documentation will be available to aid cybersecurity system design
Internal memory
- On-Chip RAM - 2.5MBytes including
  - R5F TCMA RAM - 512KB
  - R5F TCMB RAM - 256KB
  - DSS L2 RAM - 384KB
  - DSS L3 RAM - 512KB
  - DSS L3 Shared RAM - 896KB (can be shared with TCMs))
Functional Safety-Compliant Targeted
- Developed for Functional Safety Applications
- Documentation will be available to aid functional safety system design
- Hardware integrity up to ASIL B targeted as per ISO26262 standard

AEC Q-100 targeted

Clock source
- 40.0MHz crystal for primary clock
- Supports externally driven clock (Square/Sine) at 40.0MHz
- 32-kHz internal oscillator for low power operations
Supports temperature operating conditions
- Junction Temperature Range: –40°C to 140°C

FMCW Transceiver
- Integrated PLL, transmitter, receiver, baseband and ADC
- 57 - 64GHz coverage With 7 GHz continuous bandwidth
- 8 receive channels with 2:1 switching and 8 transmit channels
- 9 dBm typical output power per Tx
- 12.5 dB Typical noise figure
- -90.5 dBc/Hz typical phase noise at 1MHz
- FMCW operation
- 10 MHz IF bandwidth, real-only Rx channels
- Ultra-accurate chirp engine based on fractional-N PLL
- One binary phase shifter per transmit channel pair
Processing elements
- Arm R5F core with double precision FPU (200 MHz)
- Hardware Accelerator (HWA 1.2) for FFT, log magnitude, and CFAR operations (200 MHz)
- C66x DSP (450MHz) for post processing Radar data
Supports multiple low-power modes
- Idle mode and deep sleep mode
Power management
- 1.8-V and 3.3-V IO support
- Built-in LDO network for enhanced PSRR
- Two power rails for 1.8-V IO mode, Three power rails for 3.3-V IO mode

FCCSP package having 21 x 21 BGA grid, 329 BGA balls, Package size : 11mm x 11mm
Built-in calibration and self-test
- Built-in Firmware (ROM)
- Self-Contained on chip calibration system
Host Interface
- 3 x UART
- 2 x CAN-FD
- 2 x SPI
- 1 x LIN
LVDS for data transfer of raw ADC sample capture
Other interfaces available to user application
- QSPI
- I2C
- JTAG
- 8 x GPIOs
- PWM Interface
- 4 x GPADCs
Device security (applicable to secure device variants)
- Programmable embedded hardware security module (HSM)
- Secure authenticated and encrypted boot support
- Customer programmable root keys, symmetric keys (256 bit), asymmetric keys (up to RSA-4K or ECC-512) with key revocation capability
- Cryptographic hardware accelerators: PKA with ECC/RSA, AES (up to 256 bit), SHA (up to 512 bit), TRNG/DRBG and SM2,SM3,SM4(Chinese Crypto Algorithms)
- Product Cybersecurity Compliance
  - ISO21434 compliant up to CAL2 targeted
  - Developed for cybersecurity-relevant applications
  - Documentation will be available to aid cybersecurity system design
Internal memory
- On-Chip RAM - 2.5MBytes including
  - R5F TCMA RAM - 512KB
  - R5F TCMB RAM - 256KB
  - DSS L2 RAM - 384KB
  - DSS L3 RAM - 512KB
  - DSS L3 Shared RAM - 896KB (can be shared with TCMs))
Functional Safety-Compliant Targeted
- Developed for Functional Safety Applications
- Documentation will be available to aid functional safety system design
- Hardware integrity up to ASIL B targeted as per ISO26262 standard

AEC Q-100 targeted

Clock source
- 40.0MHz crystal for primary clock
- Supports externally driven clock (Square/Sine) at 40.0MHz
- 32-kHz internal oscillator for low power operations
Supports temperature operating conditions
- Junction Temperature Range: –40°C to 140°C

The AWRL6888 mmWave Sensor device is TI’s low power and Hardware Security Module (HSM) enabled integrated single chip mmWave sensor based on FMCW radar technology. The device is capable of operation in the 57GHz to 63.9GHz band with 7GHz continuous chirp bandwidth and is designed for various automotive in-cabin use cases. The device also takes advantage of a low power architecture to enable power-constrained applications. The device is split into the following four switchable power domains:

The AWRL6888 is specifically designed to be able to dynamically control the power states of the above-mentioned power domains based on application requirements. The device also features various low-power states and that are achieved by turning off internal IP blocks of the device. AWRL6888 device also provides the option of retaining memory during these low power states to retain critical information such as application image and RF profiles across different power modes.

A Hardware Security Module (HSM) is also provisioned in the device (available with secure part variants). The HSM consists of a programmable Arm Cortex-M4 core and the necessary infrastructure to provide a secure zone of operation within the device.

Additionally, the device is built with TI’s low power 45nm RF CMOS process and enables unprecedented levels of integration in an extremely small form factor. AWRL6888 is designed for low power, self-monitored, ultra-accurate radar systems in the automotive space for applications like child presence detection, occupancy localization & classification and low power intrusion monitoring.

The AWRL6888 mmWave Sensor device is TI’s low power and Hardware Security Module (HSM) enabled integrated single chip mmWave sensor based on FMCW radar technology. The device is capable of operation in the 57GHz to 63.9GHz band with 7GHz continuous chirp bandwidth and is designed for various automotive in-cabin use cases. The device also takes advantage of a low power architecture to enable power-constrained applications. The device is split into the following four switchable power domains:

The AWRL6888 is specifically designed to be able to dynamically control the power states of the above-mentioned power domains based on application requirements. The device also features various low-power states and that are achieved by turning off internal IP blocks of the device. AWRL6888 device also provides the option of retaining memory during these low power states to retain critical information such as application image and RF profiles across different power modes.

A Hardware Security Module (HSM) is also provisioned in the device (available with secure part variants). The HSM consists of a programmable Arm Cortex-M4 core and the necessary infrastructure to provide a secure zone of operation within the device.

Additionally, the device is built with TI’s low power 45nm RF CMOS process and enables unprecedented levels of integration in an extremely small form factor. AWRL6888 is designed for low power, self-monitored, ultra-accurate radar systems in the automotive space for applications like child presence detection, occupancy localization & classification and low power intrusion monitoring.

filter

Buscar otro/a Sensores de radar mmWave para uso automotriz

Descargar Ver vídeo con transcripción Video

Documentación técnica

No se encontraron resultados. Borre su búsqueda y vuelva a intentarlo.

Ver todo 2

Documentación principal	Tipo	Título	Opciones de formato	Descargar la versión más reciente en inglés	Fecha
*	Hoja de datos	AWRL6888 Single-Chip 57 to 64GHz Automotive Radar Sensor datasheet	PDF \| HTML		22/09/2026
*	Errata	AWRL6888 Device Silicon Errata Silicon Revisions 1.0	PDF \| HTML		22/06/2026

Diseño y desarrollo

Para conocer los términos adicionales o los recursos necesarios, haga clic en cualquier título de abajo para ver la página de detalles cuando esté disponible.

Placa de evaluación

AWRL6888EVM — Módulo de evaluación AWRL6888 para sensor de radar de onda AWRL6888 mm

The AWRL6888EVM from Texas Instruments is an easy-to-use evaluation module (EVM) for the AWRL6888 mmWave radar sensor. The AWRL6888EVM supports both standalone operation as well as direct connectivity to the DCA1000EVM for raw ADC capture and signal processing development. This EVM contains (...)

Guía del usuario: PDF | HTML

Productos y hardware compatibles

En inventario

Límite:

Inicie sesión para hacer un pedido

lock

Iniciar sesión para ver el inventario

??asset.out-of-stock-ti_es_MX??

No disponible

IDE, configuración, compilador o depurador

CCSTUDIO — Code Composer Studio™ integrated development environment (IDE)

CCStudio™ integrated development environment (IDE) is part of TI's extensive CCStudio™ development ecosystem and is an integrated development environment for TI's microcontrollers, processors, wireless connectivity devices, and radar sensors. CCStudio IDE is available as desktop or (...)

Productos y hardware compatibles

Iniciar

Opciones de descarga

Capacitación en línea

RADAR-ACADEMY — mmWave Radar Academy

The Radar Academy is a documentation package intended to provide educational resources related to mmWave radar technology

Productos y hardware compatibles

Examinar

Primeros pasos

TI-DEVELOPER-ZONE — Start embedded development on your desktop or in the cloud

From evaluation to deployment the TI Developer Zone provides a comprehensive range of software, tools and training to ensure that you have everything you need for each stage of the development process.

Productos y hardware compatibles

Empiece

Herramienta de programación de software

UNIFLASH — UniFlash for most TI microcontrollers (MCUs) and mmWave sensors

UniFlash forma parte del amplio ecosistema de desarrollo CCStudio™ de TI y es una herramienta de software diseñada para programar la memoria flash integrada en los microcontroladores y dispositivos de conectividad inalámbrica de TI, así como la memoria flash integrada en los procesadores de TI. (...)

Productos y hardware compatibles

Iniciar

Opciones de descarga

Soporte de software