TPS659128

ACTIVO

PMU para alimentación de procesador

Haga su pedido ahora

Hoja de datos

document-pdfAcrobat TPS659128 PMU for Processor Power datasheet (Rev. A) (Inglés)

TPS659128

ACTIVO

Hoja de datos

Haga su pedido ahora

Detalles del producto

Processor supplier

Generic

Processor name

Generic

Product type

Processor and FPGA

Regulated outputs (#)

14

Step-down DC/DC converter

4

Step-up DC/DC converter

0

LDO

10

Vin (min) (V)

0.8

Vin (max) (V)

5.5

Vout (min) (V)

0.5

Vout (max) (V)

3.8

Iout (max) (A)

2.5

Configurability

Factory programmable

Features

Comm control, Dynamic voltage scaling, Eco-mode, Overcurrent protection, Power sequencing, Thermal shutdown, UVLO fixed

Rating

Catalog

Operating temperature range (°C)

-40 to 105

Step-down DC/DC controller

0

Step-up DC/DC controller

0

Iq (typ) (mA)

0.008

Switching frequency (max) (kHz)

2800

Shutdown current (ISD) (typ) (µA)

3

Switching frequency (typ) (kHz)

2800

Processor supplier

Generic

Processor name

Generic

Product type

Processor and FPGA

Regulated outputs (#)

14

Step-down DC/DC converter

4

Step-up DC/DC converter

0

LDO

10

Vin (min) (V)

0.8

Vin (max) (V)

5.5

Vout (min) (V)

0.5

Vout (max) (V)

3.8

Iout (max) (A)

2.5

Configurability

Factory programmable

Features

Comm control, Dynamic voltage scaling, Eco-mode, Overcurrent protection, Power sequencing, Thermal shutdown, UVLO fixed

Rating

Catalog

Operating temperature range (°C)

-40 to 105

Step-down DC/DC controller

0

Step-up DC/DC controller

0

Iq (typ) (mA)

0.008

Switching frequency (max) (kHz)

2800

Shutdown current (ISD) (typ) (µA)

3

Switching frequency (typ) (kHz)

2800

DSBGA (YFF)

81

16 mm² (— mm × — mm)

Four step-down converters:
- Input voltage (V_IN) range from 2.7 V to 5.5 V
- Power save mode at light load current
- Output voltage accuracy in PWM mode ±2%
- Typical 26-µA quiescent current per converter
- Dynamic voltage scaling
- 100% duty cycle for lowest dropout
Ten LDOs:
- 8 general-purpose LDOs
- Output voltage range from 0.8 V to 3.3 V
- Typical 32-µA quiescent current per LDO
- 2 low-noise RF-LDOs
- Output voltage range from 1.6 V to 3.3 V
- Preregulation support by separate power inputs
- Eco-mode™ control scheme
- V_IN range of LDOs respective to the following voltage ranges:
  - 1.8 V to 3.6 V
  - 3 V to 5.5 V
Three LED drivers:
- Internal dimming using I²C
- Up to 20 mA per current sink
Thermal monitoring
- High temperature warning
- Thermal shutdown
Bypass switch
- Used with DCDC4 in applications powering a Radio Frequency Power Amplifier (RF-PA)
Interface
- I²C interface
- Power I²C interface for Dynamic Voltage Scaling (DVS)
- Serial Peripheral Interface (SPI)
32-kHz RC oscillator
Undervoltage lockout, battery fault comparator, and long button-press detection
3.6-mm × 3.6-mm DSBGA package with 0.4-mm pitch

Four step-down converters:
- Input voltage (V_IN) range from 2.7 V to 5.5 V
- Power save mode at light load current
- Output voltage accuracy in PWM mode ±2%
- Typical 26-µA quiescent current per converter
- Dynamic voltage scaling
- 100% duty cycle for lowest dropout
Ten LDOs:
- 8 general-purpose LDOs
- Output voltage range from 0.8 V to 3.3 V
- Typical 32-µA quiescent current per LDO
- 2 low-noise RF-LDOs
- Output voltage range from 1.6 V to 3.3 V
- Preregulation support by separate power inputs
- Eco-mode™ control scheme
- V_IN range of LDOs respective to the following voltage ranges:
  - 1.8 V to 3.6 V
  - 3 V to 5.5 V
Three LED drivers:
- Internal dimming using I²C
- Up to 20 mA per current sink
Thermal monitoring
- High temperature warning
- Thermal shutdown
Bypass switch
- Used with DCDC4 in applications powering a Radio Frequency Power Amplifier (RF-PA)
Interface
- I²C interface
- Power I²C interface for Dynamic Voltage Scaling (DVS)
- Serial Peripheral Interface (SPI)
32-kHz RC oscillator
Undervoltage lockout, battery fault comparator, and long button-press detection
3.6-mm × 3.6-mm DSBGA package with 0.4-mm pitch

The TPS659128x device provides four configurable step-down converters with up to 2.5-A output current and ten LDO regulators for external use. These LDOs can be supplied from either a battery or a preregulated supply. Each specific part number has a different factory programmed power-up and power-down sequence.

The TPS659128x device integrates a 32-kHz RC oscillator to sequence all resources during power up or power down. All LDOs and DC-DC converters can be controlled by an I²C or SPI interface or basic enable pins after boot. Additionally, a voltage-scaling interface allows for transitioning the DC-DC converters to a different voltage through I²C or basic roof-floor control. Three LED drivers with an advanced dimming feature are integrated inside the device. General-purpose input-output (GPIO) functionality is multiplexed with various pins, including LED pins, ENx pins, and SPI pins when not used. Each GPIO can be configured as part of the power-up sequence to control external resources. One SLEEP pin enables switching between the active mode and preprogrammed sleep mode for power optimization. The TPS659128x device comes in a 9-pin × 9-pin DSBGA package (3.6 mm × 3.6 mm) with a 0.4-mm pitch.

The TPS659128x device provides four configurable step-down converters with up to 2.5-A output current and ten LDO regulators for external use. These LDOs can be supplied from either a battery or a preregulated supply. Each specific part number has a different factory programmed power-up and power-down sequence.

The TPS659128x device integrates a 32-kHz RC oscillator to sequence all resources during power up or power down. All LDOs and DC-DC converters can be controlled by an I²C or SPI interface or basic enable pins after boot. Additionally, a voltage-scaling interface allows for transitioning the DC-DC converters to a different voltage through I²C or basic roof-floor control. Three LED drivers with an advanced dimming feature are integrated inside the device. General-purpose input-output (GPIO) functionality is multiplexed with various pins, including LED pins, ENx pins, and SPI pins when not used. Each GPIO can be configured as part of the power-up sequence to control external resources. One SLEEP pin enables switching between the active mode and preprogrammed sleep mode for power optimization. The TPS659128x device comes in a 9-pin × 9-pin DSBGA package (3.6 mm × 3.6 mm) with a 0.4-mm pitch.

filter

Buscar otro/a Circuitos integrados multicanal (PMIC)

Descargar Ver vídeo con transcripción Video

Productos similares que pueden interesarle

open-in-new

Comparar alternativas

Funcionalidad similar a la del dispositivo comparado

LP8758-EA

ACTIVO

Convertidor reductor CC-CC monofásico de 4 salidas de 4 A Similar functionality and pre-programmed to power the same application processor.

Documentación técnica

No se encontraron resultados. Borre su búsqueda y vuelva a intentarlo.

Ver todo 1

Documentación principal	Tipo	Título	Opciones de formato	Descargar la versión más reciente en inglés	Fecha
*	Hoja de datos	TPS659128 PMU for Processor Power datasheet (Rev. A)			10/06/2021

Diseño y desarrollo

Para conocer los términos adicionales o los recursos necesarios, haga clic en cualquier título de abajo para ver la página de detalles cuando esté disponible.

Controlador o biblioteca

TPS65912SW-LINUX — Controlador Linux para TPS65912

The Linux driver supports the TPS65912 Video ADC. The Linux driver supports communication through the I2C and SPI bus and interfaces with the Regulator sub-system.

Linux Mainline Status

Available in Linux Main line: Yes
Available through git.ti.com: N/A