전력 관리 AC/DC 스위칭 레귤레이터 AC/DC 컨트롤러

LM5045

활성

MOSFET 드라이버가 통합된 풀 브리지 PWM 컨트롤러

제품 상세 정보

Topology Full bridge, Half bridge, Push pull Control mode Current Features Current limiting, High-voltage startup, Integrated gate drivers, Multi-topology, SR logic, Synchronization pin Duty cycle (max) (%) 50 Sector Test & measurement
Topology Full bridge, Half bridge, Push pull Control mode Current Features Current limiting, High-voltage startup, Integrated gate drivers, Multi-topology, SR logic, Synchronization pin Duty cycle (max) (%) 50 Sector Test & measurement
HTSSOP (PWP) 28 62.08 mm² (9.7 mm × 6.4 mm) WQFN (RSG) 28 25 mm² (5 mm × 5 mm)
  • Highest Integration Controller for Small Form Factor, High-Density Power Converters
  • High-Voltage Start-Up Regulator
  • Intelligent Sync Rectifier Start-Up Allows Linear Turnon Into Prebiased Loads
  • Synchronous Rectifiers Disabled in UVLO mode and Hiccup Mode
  • Two Independent, Programmable Synchronous Rectifier Dead-Time Adjustments
  • Four High-Current 2A Bridge Gate Drivers
  • Wide-Bandwidth Optocoupler Interface
  • Configurable for Either Current Mode or Voltage Mode Control
  • Dual-Mode Overcurrent Protection
  • Resistor Programmed 2MHz Oscillator
  • Programmable Line UVLO and OVP
  • Highest Integration Controller for Small Form Factor, High-Density Power Converters
  • High-Voltage Start-Up Regulator
  • Intelligent Sync Rectifier Start-Up Allows Linear Turnon Into Prebiased Loads
  • Synchronous Rectifiers Disabled in UVLO mode and Hiccup Mode
  • Two Independent, Programmable Synchronous Rectifier Dead-Time Adjustments
  • Four High-Current 2A Bridge Gate Drivers
  • Wide-Bandwidth Optocoupler Interface
  • Configurable for Either Current Mode or Voltage Mode Control
  • Dual-Mode Overcurrent Protection
  • Resistor Programmed 2MHz Oscillator
  • Programmable Line UVLO and OVP

The LM5045 PWM controller contains all of the features necessary to implement full-bridge topology power converters using either current mode or voltage mode control. This device is intended to operate on the primary side of an isolated DC-DC converter with input voltage up to 100V. This highly integrated controller-driver provides dual 2A high-side and low-side gate drivers for the four external bridge MOSFETs plus control signals for the secondary-side synchronous rectifier MOSFETs. External resistors program the leading and trailing edge dead-time between the main and synchronous rectifier control signals. Intelligent start-up of the synchronous rectifiers allows monotonic turnon of the power converter even with prebias load conditions. Additional features include cycle-by-cycle current limiting, hiccup mode restart, programmable soft-start, synchronous rectifier soft-start, and a 2MHz capable oscillator with synchronization capability and thermal shutdown.

The LM5045 PWM controller contains all of the features necessary to implement full-bridge topology power converters using either current mode or voltage mode control. This device is intended to operate on the primary side of an isolated DC-DC converter with input voltage up to 100V. This highly integrated controller-driver provides dual 2A high-side and low-side gate drivers for the four external bridge MOSFETs plus control signals for the secondary-side synchronous rectifier MOSFETs. External resistors program the leading and trailing edge dead-time between the main and synchronous rectifier control signals. Intelligent start-up of the synchronous rectifiers allows monotonic turnon of the power converter even with prebias load conditions. Additional features include cycle-by-cycle current limiting, hiccup mode restart, programmable soft-start, synchronous rectifier soft-start, and a 2MHz capable oscillator with synchronization capability and thermal shutdown.

다운로드 스크립트와 함께 비디오 보기 비디오

기술 자료

검색된 결과가 없습니다. 검색어를 지우고 다시 시도하세요.
5개 모두 보기
상위 문서 유형 직함 형식 옵션 최신 영어 버전 다운로드 날짜
* 데이터 시트 LM5045 Full-Bridge PWM Controller With Integrated MOSFET Drivers datasheet (Rev. I) PDF | HTML 2026. 5. 14
선택 가이드 Power Management Guide 2018 (Rev. R) 2018. 6. 25
사용 설명서 AN-2111 LM5045 Evaluation Board (Rev. C) 2013. 5. 6
애플리케이션 노트 Applying I2C-Compatible Temperature Sensors in Systems With Slow Clock Edges (Rev. A) 2013. 5. 6
애플리케이션 노트 AN-2213 LM5045 Based 240W Power Converter Using Full-Wave (Rev. A) 2013. 5. 6

설계 및 개발

추가 조건 또는 필수 리소스는 사용 가능한 경우 아래 제목을 클릭하여 세부 정보 페이지를 확인하세요.

평가 보드

LM5045EVAL — LM5045용 평가 보드

LV5045 평가 보드는 LM5045 PWM 컨트롤러를 평가하도록 풀 브리지 토폴로지에 기반을 둔 완전한 기능의 전력 컨버터를 설계 엔지니어에게 제공하기 위해 설계되었습니다. 평가 보드는 업계 표준 쿼터 브릭 풋프린트로 제공됩니다.
지원되는 제품 및 하드웨어
재고 있음
제한:
??asset.out-of-stock-ti_ko_KR??
이용할 수 없음
시뮬레이션 모델

LM5045 PSPICE Model

SNVM006.ZIP (350 KB) - PSpice 모델
지원되는 제품 및 하드웨어
계산 툴

SLUC501 — LM5045 Design Calculator

지원되는 제품 및 하드웨어
레퍼런스 디자인

PMP31092 — 로우 프로파일 140W 풀 브리지 레퍼런스 설계

이 전원 공급 장치는 평면 변압기로 인해 높은 밀도와 낮은 부품 높이가 필요한 애플리케이션을 위한 140W 풀 브리지 레퍼런스 설계입니다. 이 설계는 2차측에 쇼트키 다이오드를 사용하는 하드 스위치 풀 브리지 토폴로지를 기반으로 하며 LM5045로 구동됩니다. 평면형 변압기는 풋프린트 및 높이를 최소화하는 데 사용됩니다. PCB(인쇄 회로 기판)에는 6개 레이어가 있으며 부품은 상단과 하단으로 조립됩니다. 이 장치는 주변 온도(TA) 40°C 미만의 정격 부하에서 연속 작동하도록 설계되었습니다. 주변 온도가 높은 경우 최소 (...)
지원되는 제품 및 하드웨어
패키지 CAD 기호, 풋프린트 및 3D 모델
HTSSOP (PWP) 28 Ultra Librarian
WQFN (RSG) 28 Ultra Librarian

주문 및 품질

권장 제품에는 본 TI 제품과 관련된 매개 변수, 평가 모듈 또는 레퍼런스 디자인이 있을 수 있습니다.

지원 및 교육

TI 엔지니어의 기술 지원을 받을 수 있는 TI E2E™ 포럼

콘텐츠는 TI 및 커뮤니티 기고자에 의해 "있는 그대로" 제공되며 TI의 사양으로 간주되지 않습니다. 사용 약관을 참조하십시오.

품질, 패키징, TI에서 주문하는 데 대한 질문이 있다면 TI 지원을 방문하세요. ​​​​​​​​​​​​​​

동영상