首頁 音訊、觸覺和壓電 音訊放大器 喇叭、電視與條型音箱音訊放大器
首頁
音訊、觸覺和壓電
音訊放大器
喇叭、電視與條型音箱音訊放大器

TAS5733L

現行

具有 EQ & AGL 的 10W 立體聲道、20W 單聲道、8 至 16.5V、數位輸入開環 D 類音訊放大器

立即訂購
產品規格表

TAS5733L

現行
產品規格表 立即訂購

產品詳細資料

Audio input type Digital Input Architecture Class-D Speaker channels (max) Stereo Control interface Software Output power (W) 12 Power stage supply (max) (V) 16.5 Power stage supply (min) (V) 8 RDS(on) (Ω) 0.12 THD + N at 1 kHz (%) 0.25 Load (min) (Ω) 4 Analog supply voltage (min) (V) 3 Analog supply voltage (max) (V) 3.6 Rating Catalog Operating temperature range (°C) 0 to 85
Audio input type Digital Input Architecture Class-D Speaker channels (max) Stereo Control interface Software Output power (W) 12 Power stage supply (max) (V) 16.5 Power stage supply (min) (V) 8 RDS(on) (Ω) 0.12 THD + N at 1 kHz (%) 0.25 Load (min) (Ω) 4 Analog supply voltage (min) (V) 3 Analog supply voltage (max) (V) 3.6 Rating Catalog Operating temperature range (°C) 0 to 85
HTSSOP (DCA) 48 101.25 mm² (12.5 mm × 8.1 mm)
  • Audio Input/Output
    • One-Stereo Serial Audio Input
    • Supports 44.1-kHz and 48-kHz Sample Rates
      (LJ/RJ/I²S)
    • Supports 3-Wire I²S Mode (no MCLK required)
    • Automatic Audio Port Rate Detection
    • Supports BTL and PBTL Configuration
    • POUT = 10 W @ 10% THD+N
      • PVDD = 12 V, 8 Ω, 1 kHz
  • Audio/PWM Processing
    • Independent Channel Volume Controls With
      Gain of 24 dB to Mute in 0.125-dB Steps
    • Programmable Three-Band Automatic Gain
      Limiting (AGL)
    • 20 Programmable Biquads for Speaker EQ
      and Other Audio-Processing Features
  • General Features
    • 104-dB SNR, A-Weighted, Referenced to Full
      Scale (0 dB)
    • I²C Serial Control Interface w/ two Addresses
    • Thermal, Short-Circuit, and Undervoltage
      Protection
    • Up to 90% Efficient
    • AD, BD, and Ternary Modulation
    • PWM Level Meter
  • Audio Input/Output
    • One-Stereo Serial Audio Input
    • Supports 44.1-kHz and 48-kHz Sample Rates
      (LJ/RJ/I²S)
    • Supports 3-Wire I²S Mode (no MCLK required)
    • Automatic Audio Port Rate Detection
    • Supports BTL and PBTL Configuration
    • POUT = 10 W @ 10% THD+N
      • PVDD = 12 V, 8 Ω, 1 kHz
  • Audio/PWM Processing
    • Independent Channel Volume Controls With
      Gain of 24 dB to Mute in 0.125-dB Steps
    • Programmable Three-Band Automatic Gain
      Limiting (AGL)
    • 20 Programmable Biquads for Speaker EQ
      and Other Audio-Processing Features
  • General Features
    • 104-dB SNR, A-Weighted, Referenced to Full
      Scale (0 dB)
    • I²C Serial Control Interface w/ two Addresses
    • Thermal, Short-Circuit, and Undervoltage
      Protection
    • Up to 90% Efficient
    • AD, BD, and Ternary Modulation
    • PWM Level Meter

The TAS5733L device is an efficient, digital-input audio amplifier for driving stereo speakers configured as a bridge tied load (BTL). In parallel bridge tied load (PBTL) in can produce higher power by driving the parallel outputs into a single lower impedance load. One serial data input allows processing of up to two discrete audio channels and seamless integration to most digital audio processors and MPEG decoders. The device accepts a wide range of input data and data rates. A fully programmable data path routes these channels to the internal speaker drivers.

The TAS5733L device is a slave-only device receiving all clocks from external sources. The TAS5733L device operates with a PWM carrier between a 384-kHz switching rate and a 288-kHz switching rate, depending on the input sample rate. Oversampling combined with a fourth-order noise shaper provides a flat noise floor and excellent dynamic range from 20 Hz to 20 kHz.

The TAS5733L device is an efficient, digital-input audio amplifier for driving stereo speakers configured as a bridge tied load (BTL). In parallel bridge tied load (PBTL) in can produce higher power by driving the parallel outputs into a single lower impedance load. One serial data input allows processing of up to two discrete audio channels and seamless integration to most digital audio processors and MPEG decoders. The device accepts a wide range of input data and data rates. A fully programmable data path routes these channels to the internal speaker drivers.

The TAS5733L device is a slave-only device receiving all clocks from external sources. The TAS5733L device operates with a PWM carrier between a 384-kHz switching rate and a 288-kHz switching rate, depending on the input sample rate. Oversampling combined with a fourth-order noise shaper provides a flat noise floor and excellent dynamic range from 20 Hz to 20 kHz.
filter 尋找其它 喇叭、電視與條型音箱音訊放大器
下載 觀看有字幕稿的影片 影片

索取更多資訊

提供 PurePath™ Console 3、TAS5733L GUI 和其他設計資源。立即索取

技術文件

找不到結果。請清除您的搜尋條件，然後再試一次。
檢視所有 2
重要文件 類型 標題 格式選項 下載最新的英文版本 日期
* 資料表 TAS5733L - Digital Input Audio Power Amplifier with EQ and 3-Band AGL datasheet (Rev. A) PDF | HTML 2016/3/28
更多文件說明 TAS5733LEVM Quick Start Guide 2016/4/1

設計與開發

如需其他條款或必要資源，請按一下下方的任何標題以檢視詳細頁面 (如有)。

開發板

PUREPATH-CMBEVM — 適用於音訊系統設計和開發的 PurePath™ Console 主機板

The PurePath™ Console Motherboard (PurePath-CMBEVM) provides a seamless interface between Ti’s latest PurePath Console GUI to supported TI’s digital and mixed-signal audio evaluation modules, including audio amplifiers and audio converters.

The PurePath-CMBEVM is shipped as a stand-alone board. It (...)

支援產品和硬體
有庫存
限制：
??asset.out-of-stock-ti_zh_TW??
無法提供
開發板

TAS5733LEVM — TAS5733L 數位輸入、開迴路 D 類音訊放大器評估模組

TAS5733LEVM 可用於評估德州儀器的 TAS5733L — 一款 I2S 輸入的開環式功率放大器。此評估模組上配有兩個 TAS5733L 裝置，一個設定為雙聲道運作，另一個設定為單聲道運作。TAS5733L 結合一個 PWM 處理器與開環式 D 類音訊功率放大器。TAS5733LEVM 透過單一 8V 至 16.5V 的電源供電運作。TAS5733LEVM 結合 PurePath™ Console 主機板（PurePath-CMBEVM — 需另行訂購）與 PurePath™ Console GUI（PurePathConsole — 需另行申請 (...)

使用指南: PDF
支援產品和硬體
有庫存
限制：
??asset.out-of-stock-ti_zh_TW??
無法提供
應用軟體及架構

PUREPATHCONSOLE — PurePath™ Console graphical development suite for audio system design and development

PurePath™ Console 是一款高度整合且容易使用的音訊開發套件，專爲簡化音訊產品開發相關評估、配置和偵錯程序所設計。瞭解使用 PurePath™ Console 3 軟體有多簡單。

PurePath Console 的直覺式圖形介面無需進階音訊工程專業，因此讓音訊設計更加簡明直觀。在簡單易用的圖形介面中，實作 PurePath Console 的眾多進階控制功能，並以縮短產品開發時間為目標，為您實現高度最佳化的音訊性能、最低功耗和順暢系統整合。

支援的裝置：

PurePath™ Console 1：PCM5142、TAS5721、TAS5729MD、TAS5731 和 (...)
支援產品和硬體
封裝 針腳 CAD 符號、佔位空間與 3D 模型
HTSSOP (DCA) 48 Ultra Librarian
適用 TI 的評估品項標準條款與條件。

訂購與品質

支援與培訓

內含 TI 工程師技術支援的 TI E2E™ 論壇

以英文檢視所有論壇主題

內容係由 TI 和社群貢獻者依「現狀」提供，且不構成 TI 規範。檢視使用條款。

若有關於品質、封裝或訂購 TI 產品的問題，請參閱 TI 支援。​​​​​​​​​​​​​​

影片