首頁 電源管理 LED 驅動器 汽車 LED 驅動器
首頁
電源管理
LED 驅動器
汽車 LED 驅動器

TPS929120-Q1

現行

具 FlexWire 介面的 12 通道車用 40-V 高電壓側 LED 驅動器

立即訂購
產品規格表

TPS929120-Q1

現行
產品規格表 立即訂購

產品詳細資料

Number of channels 12 Topology Current Source Rating Automotive TI functional safety category Functional Safety-Capable Operating temperature range (°C) -40 to 125 Vin (min) (V) 4.5 Vin (max) (V) 40 Iout (max) (A) 0.075 Iq (typ) (mA) 10 Features Enable/Shutdown, Fault Detection, Fault Diagnostic, LED Open Detection, LED Shorted Detection, Precision Dimming Control, Thermal shutdown
Number of channels 12 Topology Current Source Rating Automotive TI functional safety category Functional Safety-Capable Operating temperature range (°C) -40 to 125 Vin (min) (V) 4.5 Vin (max) (V) 40 Iout (max) (A) 0.075 Iq (typ) (mA) 10 Features Enable/Shutdown, Fault Detection, Fault Diagnostic, LED Open Detection, LED Shorted Detection, Precision Dimming Control, Thermal shutdown
HTSSOP (PWP) 24 49.92 mm² 7.8 x 6.4
  • AEC-Q100-qualified for automotive applications:
    • Temperature grade 1: –40°C to +125°C, TA
  • Functional Safety-Capable
  • 12-Channel precision high-side current output:
    • Supply voltage 4.5 V to 40 V
    • Up to 75 mA channel current set by resistor
    • 2-Bit global, 6-bit independent current setting
    • High current accuracy < ±5% at 5 mA to 75 mA
    • High current accuracy < ±10% at 1 mA
    • Low voltage drop 500 mV at 50 mA
    • 12-Bit independent PWM dimming
    • Programmable PWM frequency up to 20 kHz
    • Linear and exponential dimming method
  • FlexWire control interface
    • Up to 1-MHz clock frequency
    • Maximum 16 devices on one FlexWire bus
    • Up to 8 bytes data transaction in one frame
    • 5-V LDO output to supply CAN transceiver
  • Diagnostic and protection:
    • Programmable fail-safe state
    • LED open-circuit detection
    • LED short-circuit detection
    • Single-LED short-circuit diagnostic
    • Programmable low-supply detection
    • Open-drain ERR for fault indication
    • Watchdog and CRC for FlexWire interface
    • 8-Bit ADC for pin voltage measurement
    • Overtemperature protection
  • AEC-Q100-qualified for automotive applications:
    • Temperature grade 1: –40°C to +125°C, TA
  • Functional Safety-Capable
  • 12-Channel precision high-side current output:
    • Supply voltage 4.5 V to 40 V
    • Up to 75 mA channel current set by resistor
    • 2-Bit global, 6-bit independent current setting
    • High current accuracy < ±5% at 5 mA to 75 mA
    • High current accuracy < ±10% at 1 mA
    • Low voltage drop 500 mV at 50 mA
    • 12-Bit independent PWM dimming
    • Programmable PWM frequency up to 20 kHz
    • Linear and exponential dimming method
  • FlexWire control interface
    • Up to 1-MHz clock frequency
    • Maximum 16 devices on one FlexWire bus
    • Up to 8 bytes data transaction in one frame
    • 5-V LDO output to supply CAN transceiver
  • Diagnostic and protection:
    • Programmable fail-safe state
    • LED open-circuit detection
    • LED short-circuit detection
    • Single-LED short-circuit diagnostic
    • Programmable low-supply detection
    • Open-drain ERR for fault indication
    • Watchdog and CRC for FlexWire interface
    • 8-Bit ADC for pin voltage measurement
    • Overtemperature protection

With increasing demand for animation in automotive lighting, LEDs must be controlled independently. Therefore, LED drivers with digital interfaces are essential to effectively drive pixel-controlled lighting applications. In exterior lighting, multiple lamp functions are typically located on different PCB boards with off-board wires connected to each other. It is difficult for a traditional single-ended interface to meet the strict EMC requirements. By using an industrial-standard CAN physical layer, the UART-based FlexWire interface of the TPS929120-Q1 easily accomplishes long distance off-board communication without impacting EMC.

The TPS929120-Q1 is a 12-channel, 40-V high-side LED driver that controls the 8-bit output current and 12-bit PWM duty cycles. The device meets multiple regulation requirements with LED open-circuit, short-to-ground, and single LED short-circuit diagnostics. A configurable watchdog also automatically sets fail-safe states when the MCU connection is lost, and, with programmable EEPROM, TPS929120-Q1 can flexibly be set for different application scenarios.

With increasing demand for animation in automotive lighting, LEDs must be controlled independently. Therefore, LED drivers with digital interfaces are essential to effectively drive pixel-controlled lighting applications. In exterior lighting, multiple lamp functions are typically located on different PCB boards with off-board wires connected to each other. It is difficult for a traditional single-ended interface to meet the strict EMC requirements. By using an industrial-standard CAN physical layer, the UART-based FlexWire interface of the TPS929120-Q1 easily accomplishes long distance off-board communication without impacting EMC.

The TPS929120-Q1 is a 12-channel, 40-V high-side LED driver that controls the 8-bit output current and 12-bit PWM duty cycles. The device meets multiple regulation requirements with LED open-circuit, short-to-ground, and single LED short-circuit diagnostics. A configurable watchdog also automatically sets fail-safe states when the MCU connection is lost, and, with programmable EEPROM, TPS929120-Q1 can flexibly be set for different application scenarios.
filter 尋找其它 汽車 LED 驅動器
下載 觀看有字幕稿的影片 影片

您可能會感興趣的類似產品

open-in-new 比較替代產品
引腳對引腳且具備與所比較裝置相同的功能
TPS929121-Q1 現行 具 FlexWire 介面的 12 通道車用 40-V 高電壓側 LED 驅動器 Upgraded ADC range to 40 V.

技術文件

star =TI 所選的此產品重要文件
找不到結果。請清除您的搜尋條件，然後再試一次。
檢視所有 9
類型 標題 日期
* Data sheet TPS929120-Q1 12-Channel Automotive 40-V High-Side LED Driver with FlexWire datasheet (Rev. B) PDF | HTML 2021年 2月 3日
User guide TPS929xxx-Q1 Sample Code User's Guide PDF | HTML 2023年 4月 10日
White paper 簡化汽車及工業領域的功 能安全認證 2020年 6月 9日
Application note TPS929120-Q1 Fault Handling Routing 2020年 4月 17日
Application note TPS929120-Q1 Pin Failure Modes and Effects Analysis (FMEA) 2020年 2月 19日
Functional safety information TPS929120-Q1 Functional Safety FIT Rate and Failure Mode Distribution 2020年 1月 6日
Technical article New LED drivers enhance your automotive lighting solutions PDF | HTML 2019年 10月 28日
Technical article How semiconductor technologies are changing automotive lighting roadmaps PDF | HTML 2019年 10月 24日
Application note LED Temperature Protection by Vf Monitoring 2019年 5月 29日

設計與開發

如需其他條款或必要資源，請按一下下方的任何標題以檢視詳細頁面 (如有)。

開發板

TPS929120EVM — 12 通道汽車 LED 驅動器的 TPS929120-Q1 評估模組

TPS929120-Q1 評估模組 (EVM) 協助設計人員評估 TPS929120-Q1 的操作和性能，是一款具有 FlexLED 介面的 12 通道 40-V 高側 LED 驅動器，可個別控制汽車照明應用的輸出電流和 PWM 工作週期。此外也具 LED 開路、接地短路和單一 LED 短路診斷。支援在 MCU 連線遺失或沒有 MCU 控制的情況下，自動輸入預先定義的容錯狀態。
使用指南: PDF
View Options
應用軟體及架構

TPS92912XQ1-SW-F5529 — Reference code for TPS92912x-Q1 based on MSP430F5529 (MSP-EXP430F5529LP)

This reference code showcases the ability of the MSP430F5529 device to communicate with the TPS929120-Q1 and TPS929121-Q1 LED driver. The code configures the MCU using UART to drive 12 LEDs which is available on the TPS929120EVM.
支援產品和硬體

支援產品和硬體

產品
汽車 LED 驅動器
  • TPS929120-Q1 — 具 FlexWire 介面的 12 通道車用 40-V 高電壓側 LED 驅動器
  • TPS929121-Q1 — 具 FlexWire 介面的 12 通道車用 40-V 高電壓側 LED 驅動器
下載選項
開發模組 (EVM) 的 GUI

TPS929120EVM-GUI-SW — TPS929120EVM GUI

TPS929120-Q1 GUI installer
支援產品和硬體

支援產品和硬體

產品
汽車 LED 驅動器
  • TPS929120-Q1 — 具 FlexWire 介面的 12 通道車用 40-V 高電壓側 LED 驅動器
硬體開發
開發板
  • TPS929120EVM — 12 通道汽車 LED 驅動器的 TPS929120-Q1 評估模組
要求
計算工具

SLVRBF8 — TPS92912x-Q1 EEPROM Configuration Tool

支援產品和硬體

支援產品和硬體

產品
汽車 LED 驅動器
  • TPS929120-Q1 — 具 FlexWire 介面的 12 通道車用 40-V 高電壓側 LED 驅動器
  • TPS929121-Q1 — 具 FlexWire 介面的 12 通道車用 40-V 高電壓側 LED 驅動器
下載
模擬工具

PSPICE-FOR-TI — PSpice® for TI 設計與模擬工具

PSpice® for TI 是有助於評估類比電路功能的設計和模擬環境。這款全功能設計和模擬套件使用 Cadence® 的類比分析引擎。PSpice for TI 包括業界最大的模型庫之一，涵蓋我們的類比和電源產品組合，以及特定類比行為模型，且使用無需支付費用。

PSpice for TI 設計和模擬環境可讓您使用其內建函式庫來模擬複雜的混合訊號設計。在進行佈局和製造之前，建立完整的終端設備設計和解決方案原型，進而縮短上市時間並降低開發成本。 

在 PSpice for TI 設計與模擬工具中，您可以搜尋 TI (...)
要求
參考設計

TIDA-020029 — 汽車尾燈數位介面 LED 驅動模組參考設計

此參考設計為汽車後側照明應用（例如互動式尾燈儀錶板）提供符合成本效益的解決方案，可用於車輛對車輛通知和車輛設計個人化。此參考設計結合兩個線性 LED 驅動器。透過使用控制器區域網路 (CAN) 實體層（或區域互連網路 (LIN) 選項）， LED 驅動器的 UART 架構 FlexWire 介面可輕鬆達成長距離板外通訊，且無需犧牲 EMI 性能。
Design guide: PDF
電路圖: PDF
封裝 針腳 CAD 符號、佔位空間與 3D 模型
HTSSOP (PWP) 24 Ultra Librarian
適用 TI 的評估品項標準條款與條件。

訂購與品質

內含資訊：
  • RoHS
  • REACH
  • 產品標記
  • 鉛塗層/球物料
  • MSL 等級/回焊峰值
  • MTBF/FIT 估算值
  • 材料內容
  • 認證摘要
  • 進行中持續性的可靠性監測
內含資訊：
  • 晶圓廠位置
  • 組裝地點

建議產品可能具有與此 TI 產品相關的參數、評估模組或參考設計。

支援與培訓

內含 TI 工程師技術支援的 TI E2E™ 論壇

以英文檢視所有論壇主題

內容係由 TI 和社群貢獻者依「現狀」提供，且不構成 TI 規範。檢視使用條款。

若有關於品質、封裝或訂購 TI 產品的問題，請參閱 TI 支援。​​​​​​​​​​​​​​

影片