SPRADF9 January   2024 AM263P2-Q1 , AM263P4 , AM263P4-Q1

 

  1.   1
  2.   Abstract
  3.   Trademarks
  4. 1Control Card Overview
  5. 2SDK and Dependencies
    1. 2.1 Software Development Kit
    2. 2.2 Python
    3. 2.3 OpenSSL
  6. 3 Code Composer Studio
    1. 3.1 Download/Install
  7. 4Power Connections
    1. 4.1 Hardware Setup
  8. 5Build and Run Example
    1. 5.1 Device Setup
      1. 5.1.1 Configure the Device's BOOT Mode to be Used With CCS Scripting
      2. 5.1.2 Setup UART Terminal
    2. 5.2 Example Project Setup
  9. 6References

4.1 Hardware Setup

  1. Plug in power based on the above choices
  2. Plug in a microUSB cable into the JTAG-UART connector (J2)
  3. Check the power status LEDs (LD4 and LD5)

    GUID-20231212-SS0I-M4T0-8WZR-T7QW1SNCF11B-low.jpg

    Figure 4-1 AM263Px Control Card Status LEDs

If the LEDs are not illuminated as shown above, check the below resources for more information