SBOS092B June   1998  – January 2025 XTR106

PRODUCTION DATA  

  1.   1
  2. 1 Features
  3. 2 Applications
  4. 3 Description
  5. 4 Pin Configuration and Functions
  6. 5 Specifications
    1. 5.1 Absolute Maximum Ratings
    2. 5.2 Recommended Operating Conditions
    3. 5.3 Thermal Information
    4. 5.4 Electrical Characteristics
    5. 5.5 Typical Characteristics
  7. 6 Detailed Description
    1. 6.1 Overview
    2. 6.2 Functional Block Diagram
    3. 6.3 Feature Description
      1. 6.3.1 Linearization
      2. 6.3.2 Reverse-Voltage Protection
      3. 6.3.3 Overvoltage Surge Protection
    4. 6.4 Device Functional Modes
  8. 7 Application and Implementation
    1. 7.1 Application Information
      1. 7.1.1 External Transistor
      2. 7.1.2 Loop Power Supply
      3. 7.1.3 Bridge Balance
      4. 7.1.4 Underscale Current
      5. 7.1.5 Low-Impedance Bridges
      6. 7.1.6 Other Sensor Types
      7. 7.1.7 Radio Frequency Interference
      8. 7.1.8 Error Analysis
    2. 7.2 Typical Applications
    3. 7.3 Layout
    4. 7.4 Layout Guidelines
  9. 8 Device and Documentation Support
    1. 8.1 Documentation Support
    2. 8.2 Related Documentation
    3. 8.3 Receiving Notification of Documentation Updates
    4. 8.4 Support Resources
    5. 8.5 Trademarks
    6. 8.6 Electrostatic Discharge Caution
    7. 8.7 Glossary
  10. 9 Revision History
  11. 10Mechanical, Packaging, and Orderable Information

7.1.3 Bridge Balance

Figure 7-1 shows a bridge trim circuit (R1, R2). This adjustment can be used to compensate for the initial accuracy of the bridge, to trim the offset voltage of the XTR106, or both. The values of R1 and R2 depend on the impedance of the bridge, and the trim range required. This trim circuit places an additional load on the VREF output. Be sure the additional load on VREF does not affect zero output. See Figure 5-8. The effective load of the trim circuit is nearly equal to R2. An approximate value for R1 can be calculated:

Equation 11. R1≈5V×RB4×VTRIM

Where:

  • RB is the resistance of the bridge
  • VTRIM is the desired ±voltage trim range (in V)

Make R2 equal or lower in value to R1.