SBOU316A September   2024  – June 2025 INA630

 

  1.   1
  2.   Description
  3.   Get Started
  4.   Features
  5.   Applications
  6.   6
  7. 1Evaluation Module Overview
    1. 1.1 Introduction
    2. 1.2 Kit Contents
    3. 1.3 Specification
    4. 1.4 Device Information
  8. 2Hardware
    1. 2.1 EVM General Overview
    2. 2.2 Setup and Connections
    3. 2.3 Power Requirements
    4. 2.4 Jumper and Vref Input Information
    5. 2.5 Test Points
    6. 2.6 Adjusting INA630 Gain
  9. 3Hardware Design Files
    1. 3.1 Schematics
    2. 3.2 PCB Layouts
    3. 3.3 Bill of Materials (BOM)
  10. 4Additional Information
    1. 4.1 Trademarks
  11. 5Revision History

1.3 Specification

The INA630EVM provides a mechanism for connecting signal in and out of the INA630DDFR device. The printed circuit board (PCB) is 3.00 × 3.35 inch in size using FR4 material. The power supply, input, and output signals are connected using banana cables or mini-clips to test points. The gain is set with resistors on the PCB (default of 201V/V installed on the EVM).