SLUUD38A June   2024  – July 2025 TPSM82866A , TPSM82866C

 

  1.   1
  2.   Description
  3.   Features
  4.   4
  5. 1Evaluation Module Overview
    1. 1.1 Introduction
    2. 1.2 Kit Contents
    3. 1.3 Specification
    4. 1.4 Device Information
  6. 2Hardware
    1. 2.1 Safety Instructions
    2. 2.2 Header Information
    3. 2.3 Jumper Information
    4. 2.4 Interfaces
    5. 2.5 Test Points
  7. 3Software
  8. 4Implementation Results
    1. 4.1 Evaluation Setup
      1. 4.1.1 VSET/VID Resistor (TPSM82866CAxPEVM Only)
      2. 4.1.2 VSET/MODE Resistor (TPSM82866AA0PEVM Only)
      3. 4.1.3 Input and Output Capacitors
      4. 4.1.4 Feedforward Capacitor
      5. 4.1.5 Loop Response Measurement
    2. 4.2 Performance Data and Results
  9. 5Hardware Design Files
    1. 5.1 Schematics
    2. 5.2 PCB Layout
    3. 5.3 Bill of Materials (BOM)
  10. 6Additional Information
    1. 6.1 Revision A EVMs
      1. 6.1.1 Rev A. Schematic
      2. 6.1.2 Rev. A Bill of Materials (BOM)
      3. 6.1.3 Rev. A PCB Layout
      4. 6.1.4 Rev. A Loop Response
    2. 6.2 Trademarks
  11. 7Revision History

2.4 Interfaces

J6 – I2C

TPSM82866CAxPEVM only.

I2C adapter connection. Connect the 10-pin ribbon cable from the USB2ANY adapter EVM to this header to communicate with the device over the I2C bus through the TPSM8286xC EVM GUI. This header is keyed to prevent backwards installation. The TPSM82866CAxPEVM does not require the USB2ANY EVM to operate.