SLVSJF0A October 2025 – July 2026 DRV7167
ADVANCE INFORMATION
As described in Pin Functions, turn-on and turn-off drive strength of HS and LS FETs are controlled independently through:
Using the above listed resistors allows users to optimize the tradeoff between higher efficiency (faster slew rates) and lower ringing (slower slew rates). Figure 8-12 and Figure 8-13 shows the typical variation of slew rate with resistor. The circuitry in the device adjusts drive strength versus temperature to keep constant slew rate across the temperature. Therefore, overall gate loop remains small because RDxx is not in main gate drive loop, achieving better performance than a discrete gate driver with an external gate resistor.
| Drain Current = 20A | VM = 48V |
| Drain Current = 20A | VM = 48V |