SNVSA85D October   2015  – October 2025 LM27761

PRODUCTION DATA  

  1.   1
  2. 1 Features
  3. 2 Applications
  4. 3 Description
  5. 4 Pin Configuration and Functions
  6. 5 Specifications
    1. 5.1 Absolute Maximum Ratings
    2. 5.2 ESD Ratings
    3. 5.3 Recommended Operating Conditions
    4. 5.4 Thermal Information
    5. 5.5 Electrical Characteristics
    6. 5.6 Typical Characteristics
  7. 6 Detailed Description
    1. 6.1 Overview
    2. 6.2 Functional Block Diagram
    3. 6.3 Feature Description
      1. 6.3.1 Undervoltage Lockout
      2. 6.3.2 Input Current Limit
      3. 6.3.3 PFM Operation
      4. 6.3.4 Output Discharge
      5. 6.3.5 Thermal Shutdown
    4. 6.4 Device Functional Modes
      1. 6.4.1 Shutdown Mode
      2. 6.4.2 Enable Mode
  8. 7 Application and Implementation
    1. 7.1 Application Information
    2. 7.2 Typical Application - Regulated Voltage Inverter
      1. 7.2.1 Design Requirements
      2. 7.2.2 Detailed Design Procedure
        1. 7.2.2.1 Charge-Pump Voltage Inverter
        2. 7.2.2.2 Negative Low-Dropout Linear Regulator
        3. 7.2.2.3 Power Dissipation
        4. 7.2.2.4 Output Voltage Setting
        5. 7.2.2.5 External Capacitor Selection
          1. 7.2.2.5.1 Charge-Pump Output Capacitor
          2. 7.2.2.5.2 Input Capacitor
          3. 7.2.2.5.3 Flying Capacitor
          4. 7.2.2.5.4 LDO Output Capacitor
      3. 7.2.3 Application Curves
    3. 7.3 Power Supply Recommendations
    4. 7.4 Layout
      1. 7.4.1 Layout Guidelines
      2. 7.4.2 Layout Example
  9. 8 Device and Documentation Support
    1. 8.1 Receiving Notification of Documentation Updates
    2. 8.2 Support Resources
    3. 8.3 Trademarks
    4. 8.4 Electrostatic Discharge Caution
    5. 8.5 Glossary
  10. 9 Revision History
  11. 10Mechanical, Packaging, and Orderable Information

4 Pin Configuration and Functions

LM27761 DSG Package8-Pin WSON With Thermal PadTop ViewFigure 4-1 DSG Package8-Pin WSON With Thermal PadTop View
Table 4-1 Pin Functions
PIN TYPE(1) DESCRIPTION
NUMBER NAME
1 VIN P Positive power supply input.
2 GND G Ground
3 CPOUT P Negative unregulated output voltage.
4 VOUT P Regulated negative output voltage.
5 VFB P Feedback input. Connect VFB to an external resistor divider between VOUT and GND. DO NOT leave unconnected.
6 EN I Active high enable input.
7 C1– P Negative terminal for C1.
8 C1+ P Positive terminal for C1.
— Thermal Pad G Ground. DO NOT leave unconnected.
(1) P: Power; G: Ground; I: Input.