SWRA493A October   2015  – October 2026 CC1101 , CC110L , CC1120 , CC1121 , CC1125 , CC1190 , MSP430F5438A

 

  1.   1
  2.   CC112x-CC1190 Boost Software Examples
  3.   Trademarks
  4. 1Features and Benefits of UART-Based Test Suite
    1. 1.1  Continuous Unmodulated TX
    2. 1.2  Continuous Modulated TX
    3. 1.3  Static RX
    4. 1.4  TX Single Channel BER
    5. 1.5  RX Single Channel BER
    6. 1.6  TX Frequency Hopping BER
    7. 1.7  RX Frequency Hopping BER
    8. 1.8  RX Sniff Mode
    9. 1.9  SmartRF Selector
    10. 1.10 Radio Setup
    11. 1.11 Automatic Mode
  5. 2Hardware Requirements to Run the Software
  6. 3Configuring Hardware Options
  7. 4Port to Test Software to Custom Hardware
    1. 4.1 SPI Configuration for the Transceiver
    2. 4.2 Chip Select for the Transceiver
    3. 4.3 Reset Pin for the Transceiver
    4. 4.4 Interrupt Configuration for the Transceiver
    5. 4.5 Optional Control Pins for the Range Extender
    6. 4.6 Optional Pins for Creating a Button User Interface
    7. 4.7 Optional LED Pin Configuration
  8. 5References
  9. 6Revision History

4.4 Interrupt Configuration for the Transceiver

These next sets of definitions configure the location of the interrupt enabled signals between the transceiver and the MCU.

/* Transceiver interrupt configuration */
#define     RF_PORT_VECTOR         PORT2_VECTOR
#define     RF_GDO_OUT             P2OUT
#define     RF_GDO_DIR             P2DIR
#define     RF_GDO_IN              P2IN
#define     RF_GDO_SEL             P2SEL
#define     RF_GDO_PxIES           P2IES
#define     RF_GDO_PxIFG           P2IFG
#define     RF_GDO_PxIE            P2IE
#define     RF_GDO_PIN             BIT0
/* Transceiver interrupt configuration */
#define     RF_PORT_VECTOR         PORT2_VECTOR
#define     RF_GDO_OUT             P2OUT
#define     RF_GDO_DIR             P2DIR
#define     RF_GDO_IN              P2IN
#define     RF_GDO_SEL             P2SEL
#define     RF_GDO_PxIES           P2IES
#define     RF_GDO_PxIFG           P2IFG
#define     RF_GDO_PxIE            P2IE
#define     RF_GDO_PIN             BIT0