SWRU635 May   2025 CC2744R7-Q1 , CC2745P10-Q1 , CC2745R10-Q1 , CC2745R7-Q1

 

  1.   1
  2.   Description
  3.   Get Started
  4.   Features
  5.   Applications
  6.   6
  7. 1Evaluation Module Overview
    1. 1.1 Introduction
    2. 1.2 Kit Contents
    3. 1.3 Specification
    4. 1.4 Device Information
  8. 2Hardware
    1. 2.1 Power Requirements
    2. 2.2 Temperature Range
    3. 2.3 Energy Trace
    4. 2.4 Hardware and Debug Setup
      1. 2.4.1 Using a LaunchPad XDS110 Debug Probe
      2. 2.4.2 Using a Generic XDS110 Debug Probe, Including a Separate LaunchPad
    5. 2.5 BoosterPack Connector Pinout
    6. 2.6 XDS110 Interface Connector
    7. 2.7 Debug Interface Connector
    8. 2.8 Jumper Information
    9. 2.9 Push Buttons
  9. 3Advanced Use of the LaunchPad Hardware
    1. 3.1 External Antenna
    2. 3.2 XDS110 GPIOs
    3. 3.3 Reset Selection on BoosterPack Connector
    4. 3.4 I2C Pullup Resistors
  10. 4Software
    1. 4.1 Getting Started
    2. 4.2 Out of Box Demo
  11. 5Hardware Design Files
    1. 5.1 Reference Schematics
    2. 5.2 PCB Layouts
    3. 5.3 Bill of Materials (BOM)
  12. 6Compliance Information
    1. 6.1 CE Compliance
    2. 6.2 REACH Compliance
    3. 6.3 Waste Electrical and Electronic Equipment (WEEE) Compliance
  13. 7Additional Information
    1. 7.1 Trademarks
  14. 8References

1.1 Introduction

The CC2745R10-Q1 LaunchPad kit (LP-EM-CC2745R10-Q1) brings easy Bluetooth Low Energy connectivity to the LaunchPad ecosystem with the SimpleLink ultra-low power CC2745R10-Q1 wireless MCU.

The CC2745R10-Q1 is a wireless MCU targeting Bluetooth Low Energy and Proprietary 2.4GHz applications. The CC2745R10-Q1 has a 96MHz, 32-bit Arm Cortex-M0+ as the main processor and a rich peripheral set that includes 12-bit ADC, 2xUART, 2xSPI, I2C, I2S, CAN, Hardware Security Module (HSM), Timers, Algorithm Processing Unit (APU), and more. More detailed information is provided in the devices data sheet and Technical Reference Manual (TRM).

The LaunchPad is supported by the SimpleLink Starter app for iOS™ and Andriod™. This app connects your LaunchPad to a smartphone using Bluetooth. The Starter app supports reading the LaunchPad buttons, controlling LEDs, and all I/O signals on the BoosterPack connectors.

Additionally, the latest firmware version can be uploaded to the LaunchPad kit via an over-the-air (OTA) upgrade from the SimpleLink Starter application.