OPA4314-Q1

ACTIVO

Amplificador operacional RRIO, cuádruple, 5,5 V, 3 MHz, bajo ruido (4,6-nV/√Hz), de grado automotriz

Haga su pedido ahora

Hoja de datos

document-pdfAcrobat OPAx314-Q1 3-MHz, Low-Power, Low-Noise, RRIO, 1.8-V CMOS Operational Amplifier datasheet (Rev. B) (Inglés) PDF | HTML

Se encuentra disponible una versión más nueva de este producto

open-in-new

Comparar alternativas

Pin por pin con la misma funcionalidad que el dispositivo comparado

TSV914A-Q1

ACTIVO

Amplificador operacional RRIO cuádruple de calidad automotriz, de 5.5 V y 8 MHz Higher GBW (8 MHz), faster slew rate (6.5 V/us), lower offset voltage (1.5 mV), higher output current (50 mA)

OPA4314-Q1

ACTIVO

Hoja de datos

Haga su pedido ahora

Detalles del producto

Number of channels

4

Total supply voltage (+5 V = 5, ±5 V = 10) (max) (V)

5.5

Total supply voltage (+5 V = 5, ±5 V = 10) (min) (V)

1.8

Rail-to-rail

In, Out

GBW (typ) (MHz)

3

Slew rate (typ) (V/µs)

1.5

Vos (offset voltage at 25°C) (max) (mV)

2.5

Iq per channel (typ) (mA)

0.13

Vn at 1 kHz (typ) (nV√Hz)

14

Rating

Automotive

Operating temperature range (°C)

-40 to 125

Offset drift (typ) (µV/°C)

1

Features

EMI Hardened

Input bias current (max) (pA)

10

CMRR (typ) (dB)

96

Iout (typ) (A)

0.02

Architecture

CMOS

Input common mode headroom (to negative supply) (typ) (V)

-0.2

Input common mode headroom (to positive supply) (typ) (V)

0.2

Output swing headroom (to negative supply) (typ) (V)

0.005

Output swing headroom (to positive supply) (typ) (V)

-0.005

Number of channels

4

Total supply voltage (+5 V = 5, ±5 V = 10) (max) (V)

5.5

Total supply voltage (+5 V = 5, ±5 V = 10) (min) (V)

1.8

Rail-to-rail

In, Out

GBW (typ) (MHz)

3

Slew rate (typ) (V/µs)

1.5

Vos (offset voltage at 25°C) (max) (mV)

2.5

Iq per channel (typ) (mA)

0.13

Vn at 1 kHz (typ) (nV√Hz)

14

Rating

Automotive

Operating temperature range (°C)

-40 to 125

Offset drift (typ) (µV/°C)

1

Features

EMI Hardened

Input bias current (max) (pA)

10

CMRR (typ) (dB)

96

Iout (typ) (A)

0.02

Architecture

CMOS

Input common mode headroom (to negative supply) (typ) (V)

-0.2

Input common mode headroom (to positive supply) (typ) (V)

0.2

Output swing headroom (to negative supply) (typ) (V)

0.005

Output swing headroom (to positive supply) (typ) (V)

-0.005

TSSOP (PW)

14

32 mm² (5 mm × 6.4 mm)

Qualified for Automotive Applications
AEC-Q100 Qualified With the Following Results:
- Device Temperature Grade : –40°C to +125°C Ambient Operating Temperature Range
- Device HBM Classification Level 2
- Device CDM Classification Level C6
Low I_Q: 150 µA/ch
Wide Supply Range: 1.8 V to 5.5 V
Low Noise: 14 nV/√Hz at 1 kHz
Gain Bandwidth: 3 MHz
Low Input Bias Current: 0.2 pA
Low Offset Voltage: 0.5 mV
Unity-Gain Stable
Internal RF/EMI Filter
Specified Temperature Range: –40°C to +125°C

Qualified for Automotive Applications
AEC-Q100 Qualified With the Following Results:
- Device Temperature Grade : –40°C to +125°C Ambient Operating Temperature Range
- Device HBM Classification Level 2
- Device CDM Classification Level C6
Low I_Q: 150 µA/ch
Wide Supply Range: 1.8 V to 5.5 V
Low Noise: 14 nV/√Hz at 1 kHz
Gain Bandwidth: 3 MHz
Low Input Bias Current: 0.2 pA
Low Offset Voltage: 0.5 mV
Unity-Gain Stable
Internal RF/EMI Filter
Specified Temperature Range: –40°C to +125°C

The OPAx314-Q1 series is a family of single-, and dual-, and quad-channel operational amplifiers (op-amps) that represents a new generation of low-power, general-purpose CMOS amplifiers. Rail-to-rail input and output swings, low quiescent current (150 µA typically at 5 V_S) combined with a wide bandwidth of 3 MHz, and very low noise (14 nV/√Hz at 1 kHz) make this device family very attractive for a variety of battery-powered applications that require a good balance between cost and performance. The low input bias current supports applications with mega-ohm source impedances.

The robust design of the OPAx314-Q1 series provides ease-of-use to the circuit designer: unity-gain stability with capacitive loads of up to 300 pF, an integrated RF/EMI rejection filter, no phase reversal in overdrive conditions, and high electrostatic discharge (ESD) protection (4-kV HBM).

The device is optimized for low-voltage operation as low as 1.8 V (±0.9 V) and up to 5.5 V (±2.75 V), and is specified over the full extended temperature range of –40°C to +125°C.

The single-channel device, OPA314-Q1, is offered in the SOT-23 package and the dual-channel device, OPA2314-Q1, is offered in the VSSOP (8) package. The quad-channel OPA4314-Q1 is available in the 14-pin TSSOP package.

The OPAx314-Q1 series is a family of single-, and dual-, and quad-channel operational amplifiers (op-amps) that represents a new generation of low-power, general-purpose CMOS amplifiers. Rail-to-rail input and output swings, low quiescent current (150 µA typically at 5 V_S) combined with a wide bandwidth of 3 MHz, and very low noise (14 nV/√Hz at 1 kHz) make this device family very attractive for a variety of battery-powered applications that require a good balance between cost and performance. The low input bias current supports applications with mega-ohm source impedances.

The robust design of the OPAx314-Q1 series provides ease-of-use to the circuit designer: unity-gain stability with capacitive loads of up to 300 pF, an integrated RF/EMI rejection filter, no phase reversal in overdrive conditions, and high electrostatic discharge (ESD) protection (4-kV HBM).

The device is optimized for low-voltage operation as low as 1.8 V (±0.9 V) and up to 5.5 V (±2.75 V), and is specified over the full extended temperature range of –40°C to +125°C.

The single-channel device, OPA314-Q1, is offered in the SOT-23 package and the dual-channel device, OPA2314-Q1, is offered in the VSSOP (8) package. The quad-channel OPA4314-Q1 is available in the 14-pin TSSOP package.

filter

Buscar otro/a Amplificadores de propósito general

Descargar Ver vídeo con transcripción Video

Documentación técnica

No se encontraron resultados. Borre su búsqueda y vuelva a intentarlo.

Ver todo 2

Documentación principal	Tipo	Título	Opciones de formato	Descargar la versión más reciente en inglés	Fecha
*	Hoja de datos	OPAx314-Q1 3-MHz, Low-Power, Low-Noise, RRIO, 1.8-V CMOS Operational Amplifier datasheet (Rev. B)	PDF \| HTML		13/01/2017
	Libro electrónico	The Signal e-book: A compendium of blog posts on op amp design topics	PDF \| HTML		28/03/2017

Diseño y desarrollo

Para conocer los términos adicionales o los recursos necesarios, haga clic en cualquier título de abajo para ver la página de detalles cuando esté disponible.

Placa de evaluación

AMP-PDK-EVM — Módulo de evaluación del kit de desarrollo del rendimiento del amplificador

El kit de desarrollo del rendimiento (PDK) del amplificador es un kit de módulo de evaluación (EVM) para probar los parámetros comunes del amplificador operacional y es compatible con la mayoría de los amplificadores operacionales y comparadores. El kit de EVM ofrece una placa principal con varias (...)

Guía del usuario: PDF | HTML