Inicio Amplificadores Amplificadores de ganancia programable y variable (PGA y VGA)
Inicio
Amplificadores
Amplificadores de ganancia programable y variable (PGA y VGA)

VCA5807

ACTIVO

Amplificador de 8 canales controlado por tensión y totalmente integrado con mezclador pasivo CW

Haga su pedido ahora
Hoja de datos

VCA5807

ACTIVO
Hoja de datos Haga su pedido ahora

Detalles del producto

PGA/VGA VGA Number of channels 8 Vs (min) (V) 3.15 Vs (max) (V) 5.5 Input type Single-ended Output type Differential BW at Acl (MHz) 200 Acl, min spec gain (V/V) 1 Gain (max) (dB) 54 Features Analog Gain Set, Digital Gain Set, Shutdown Rating Catalog Operating temperature range (°C) -40 to 85
PGA/VGA VGA Number of channels 8 Vs (min) (V) 3.15 Vs (max) (V) 5.5 Input type Single-ended Output type Differential BW at Acl (MHz) 200 Acl, min spec gain (V/V) 1 Gain (max) (dB) 54 Features Analog Gain Set, Digital Gain Set, Shutdown Rating Catalog Operating temperature range (°C) -40 to 85
HTQFP (PZP) 100 256 mm² (16 mm × 16 mm)
  • 8-Channel Voltage Controlled Amplifier
    • LNA, VCAT, PGA, LPF, and CW Mixer
  • Programmable Low-Noise Amplifier (LNA)
    • 24/18/12 dB Gain
    • 0.25/0.5/1 VPP Linear Input Range
    • 0.63/0.7/0.9 nV/rtHz Input Referred Noise
    • Programmable Active Termination
  • 40 dB Low Noise Voltage Controlled Attenuator (VCAT)
  • 24/30 dB Programmable Gain Amplifier (PGA)
  • 3rd Order Linear Phase Low-Pass Filter (LPF)
    • 10, 15, 20, 30 MHz
    • Butterworth Characteristics
  • Noise/Power Optimizations (Full Chain)
    • 99 mW/CH at 0.75 nV/rtHz
    • 56 mW/CH at 1.1 nV/rtHz
    • 80 mW/CH at CW Mode
  • Excellent Device-to-Device Gain Matching
    • ±0.5 dB (typical) and ±1.05 dB (max)
  • Low Harmonic Distortion
  • Fast and Consistent Overload Recovery
  • Low Frequency Sonar Signal Processing
  • Passive Mixer for Continuous Wave Doppler (CWD)
    • Low Close-in Phase Noise –156 dBc/Hz at 1 KHz off 2.5 MHz Carrier
    • Phase Resolution of 1/16λ
    • Support 32X,16X, 8X, 4X and 1X CW Clocks
    • 12dB Suppression on 3rd and 5th Harmonics
    • Flexible Input Clocks
  • 14mm x 14mm, 100-pin TQFP
  • 8-Channel Voltage Controlled Amplifier
    • LNA, VCAT, PGA, LPF, and CW Mixer
  • Programmable Low-Noise Amplifier (LNA)
    • 24/18/12 dB Gain
    • 0.25/0.5/1 VPP Linear Input Range
    • 0.63/0.7/0.9 nV/rtHz Input Referred Noise
    • Programmable Active Termination
  • 40 dB Low Noise Voltage Controlled Attenuator (VCAT)
  • 24/30 dB Programmable Gain Amplifier (PGA)
  • 3rd Order Linear Phase Low-Pass Filter (LPF)
    • 10, 15, 20, 30 MHz
    • Butterworth Characteristics
  • Noise/Power Optimizations (Full Chain)
    • 99 mW/CH at 0.75 nV/rtHz
    • 56 mW/CH at 1.1 nV/rtHz
    • 80 mW/CH at CW Mode
  • Excellent Device-to-Device Gain Matching
    • ±0.5 dB (typical) and ±1.05 dB (max)
  • Low Harmonic Distortion
  • Fast and Consistent Overload Recovery
  • Low Frequency Sonar Signal Processing
  • Passive Mixer for Continuous Wave Doppler (CWD)
    • Low Close-in Phase Noise –156 dBc/Hz at 1 KHz off 2.5 MHz Carrier
    • Phase Resolution of 1/16λ
    • Support 32X,16X, 8X, 4X and 1X CW Clocks
    • 12dB Suppression on 3rd and 5th Harmonics
    • Flexible Input Clocks
  • 14mm x 14mm, 100-pin TQFP

The VCA5807 is an integrated Voltage Controlled Amplifier (VCA) specifically designed for ultrasound systems in which high performance and small size are required. The VCA5807 integrates a complete time-gain-control (TGC) imaging path and a continuous wave Doppler (CWD) path. It also enables users to select one of various power/noise combinations to optimize system performance. Therefore, the VCA5807 is a suitable ultrasound analog front end solution not only for high-end systems, but also for portable systems.

The VCA5807 contains eight channels of voltage controlled amplifier (VCA), and CW mixer. The VCA includes Low noise Amplifier(LNA), Voltage controlled Attenuator (VCAT), Programmable Gain Amplifier (PGA), and Low-Pass Filter (LPF). The LNA gain is programmable to support 250 mVPP to 1 VPP input signals. Programmable active termination is also supported by the LNA. The ultra-low noise VCAT provides an attenuation control range of 40dB and improves overall low gain SNR which benefits harmonic imaging and near field imaging. The PGA provides gain options of 24 dB and 30 dB. Before the ADC, a LPF can be configured as 10 MHz, 15 MHz, 20 MHz, or 30 MHz to support ultrasound applications with different frequencies. In addition, the signal chain of the VCA5807 can handle signal frequency lower than 100 KHz, which enables it to be used not only in ultrasound applications but also in sonar applications.

The VCA5807 integrates a low power passive mixer and a low noise summing amplifier to accomplish on-chip CWD beamformer. 16 selectable phase-delays can be applied to each analog input signal. Meanwhile a unique 3rd and 5th order harmonic suppression filter is implemented to enhance CW sensitivity.

The VCA5807 is available in a 14mm x 14mm, 100-pin TQFP package and it is specified for operation from -40°C to 85°C.

The VCA5807 is an integrated Voltage Controlled Amplifier (VCA) specifically designed for ultrasound systems in which high performance and small size are required. The VCA5807 integrates a complete time-gain-control (TGC) imaging path and a continuous wave Doppler (CWD) path. It also enables users to select one of various power/noise combinations to optimize system performance. Therefore, the VCA5807 is a suitable ultrasound analog front end solution not only for high-end systems, but also for portable systems.

The VCA5807 contains eight channels of voltage controlled amplifier (VCA), and CW mixer. The VCA includes Low noise Amplifier(LNA), Voltage controlled Attenuator (VCAT), Programmable Gain Amplifier (PGA), and Low-Pass Filter (LPF). The LNA gain is programmable to support 250 mVPP to 1 VPP input signals. Programmable active termination is also supported by the LNA. The ultra-low noise VCAT provides an attenuation control range of 40dB and improves overall low gain SNR which benefits harmonic imaging and near field imaging. The PGA provides gain options of 24 dB and 30 dB. Before the ADC, a LPF can be configured as 10 MHz, 15 MHz, 20 MHz, or 30 MHz to support ultrasound applications with different frequencies. In addition, the signal chain of the VCA5807 can handle signal frequency lower than 100 KHz, which enables it to be used not only in ultrasound applications but also in sonar applications.

The VCA5807 integrates a low power passive mixer and a low noise summing amplifier to accomplish on-chip CWD beamformer. 16 selectable phase-delays can be applied to each analog input signal. Meanwhile a unique 3rd and 5th order harmonic suppression filter is implemented to enhance CW sensitivity.

The VCA5807 is available in a 14mm x 14mm, 100-pin TQFP package and it is specified for operation from -40°C to 85°C.
filter Buscar otro/a Amplificadores de ganancia programable y variable (PGA y VGA)
Descargar Ver vídeo con transcripción Video

Documentación técnica

No se encontraron resultados. Borre su búsqueda y vuelva a intentarlo.
Ver todo 1
Documentación principal Tipo Título Opciones de formato Descargar la versión más reciente en inglés Fecha
* Hoja de datos Fully Integrated, 8-Channel Voltage Controlled Amplifier for Ultrasound datasheet 4/12/2012

Diseño y desarrollo

Para conocer los términos adicionales o los recursos necesarios, haga clic en cualquier título de abajo para ver la página de detalles cuando esté disponible.

Placa de evaluación

VCA5807EVM — Módulo de evaluación VCA5807

The VCA5807 is an integrated Voltage Controlled Amplifier(VCA) solution specifically designed for ultrasound systems in which high performance and small size are required. The VCA5807 integrates a complete time-gain-control(TGC) imaging path and a continuous wave Doppler(CWD) path. It also enables (...)

Guía del usuario: PDF
Productos y hardware compatibles
En inventario
Límite:
??asset.out-of-stock-ti_es_MX??
No disponible
GUI para el módulo de evaluación (EVM)

SLOC282 — VCA5807EVM GUI

Productos y hardware compatibles
Modelo de simulación

VCA5807 PSpice Model

SLOM347.ZIP (69 KB) - Modelo PSpice
Productos y hardware compatibles
Modelo de simulación

VCA5807 PSpice Transient Model

SLOM346.ZIP (39 KB) - Modelo PSpice
Productos y hardware compatibles
Modelo de simulación

VCA5807 TINA-TI Reference Design

SLOM340.TSC (106 KB) - Diseño de referencia TINA-TI
Productos y hardware compatibles
Modelo de simulación

VCA5807 TINA-TI Spice Model

SLOM339.ZIP (63 KB) - Modelo TINA-TI Spice
Productos y hardware compatibles
Modelo de simulación

VCA5807 TINA-TI Transient Reference Design

SLOM344.TSC (63 KB) - Diseño de referencia TINA-TI
Productos y hardware compatibles
Modelo de simulación

VCA5807 TINA-TI Transient Spice Model

SLOM345.ZIP (35 KB) - Modelo TINA-TI Spice
Productos y hardware compatibles
Encapsulado Pines Símbolos CAD, huellas y modelos 3D
HTQFP (PZP) 100 Ultra Librarian
Se aplican los Términos y condiciones estándar de TI para los elementos de evaluación.

Pedidos y calidad

Soporte y capacitación

Foros de TI E2E™ con asistencia técnica de los ingenieros de TI

Ver todos los temas del foro en inglés

El contenido lo proporcionan “tal como está” TI y los colaboradores de la comunidad y no constituye especificaciones de TI. Consulte los términos de uso.

Si tiene alguna pregunta sobre calidad, encapsulados o pedido de productos de TI, consulte el servicio de asistencia de TI. ​​​​​​​​​​​​​​

Videos