SLVSM66 November 2026 DP83C8201F
ADVANCE INFORMATION
Refer to the PDF data sheet for device specific package drawings
This section describes the hardware configuration available for DP83C8201Fx'. If no strap resistors are implemented, the default value is Odd Nibble Enabled, MII mode, FLD disabled. '0' corresponds to Mode 0 while '1' corresponds to Mode 1.
The FLD hardware strapping is only supported on DP83C8201FxM. DP83C8201FxRL and DP83C8201FxRF do not support FLD hardware strapping. FLD register configuration is available for all three variants.
| PIN NAME | PIN NO. | DEFAULT | MODE | FUNCTION |
|---|---|---|---|---|
| LED0 | 24 | 0 | PHY_ADDR | |
| 0 | 0 | |||
| 1 | 1 | |||
| LED1/CLKOUT | 25 | 1 | 0 | Real-time Ethernet |
| 1 | Standard Ethernet | |||
| RX_D3 | 12 | 0 | 0 | Disable FLD |
| RX_CLK | 13 | 1 | Enable FLD | |
| RX_ER | 28 | 0 | 0 | CLKOUT 25MHz on Pin 25 |
| 1 | LED1 on Pin 25 |
| PIN NAME | PIN NO. | DEFAULT | MODE | FUNCTION |
|---|---|---|---|---|
| LED0 | 24 | 0 | PHY_ADDR | |
| 0 | 0 | |||
| 1 | 1 | |||
| RMII_EN | 8 | 0 | 1 | RMII Enable |
| LED1_EN | 28 | 0 | 0 | CLKOUT 25MHz on Pin 25 |
| 1 | LED1 on Pin 25 |
| PIN NAME | PIN NO. | DEFAULT | MODE | FUNCTION |
|---|---|---|---|---|
| LED0 | 24 | 0 | PHY_ADDR | |
| 0 | 0 | |||
| 1 | 1 | |||
| RMII_EN | 8 | 0 | 1 | RMII Enable |
| RF_EN | 12 | 0 | 1 | RF Enable |
| LED1_EN | 28 | 0 | 0 | CLKOUT 25MHz on Pin 25 |
| 1 | LED1 on Pin 25 |