SLLA661 April   2025 MCF8315A , MCF8315C , MCF8315C-Q1 , MCF8315D , MCF8316A , MCF8316C-Q1 , MCF8316D , MCF8329A , MCF8329A-Q1

 

  1.   1
  2.   Abstract
  3.   Trademarks
  4. 1Introduction
  5. 2Prerequisites to Run the Motor with MOTORSTUDIO
  6. 3Getting Started with MOTORSTUDIO
    1. 3.1 Motor Parameters
      1. 3.1.1 Manual Measurements
        1. 3.1.1.1 Entering Manual Measurements Into MOTORSTUDIO
      2. 3.1.2 Motor Parameter Extraction Tool Measurements
        1. 3.1.2.1 Motor BEMF Constant Measurement Through MPET – Along With Motor Resistance and Motor Inductance for MCF8315C, 16C
        2. 3.1.2.2 Mechanical Parameters (SPD_LOOP_KP, SPD_LOOP_KI) Measurement Through MPET
  7. 4Motor Runs
  8. 5Summary
  9. 6References

4 Motor Runs

Use the right panel to run the motor now.

Motor Runs Right Panel Figure 4-1 Motor Runs Right Panel
  • Enable I2C Speed Command Percentage till 30%, make sure faults status is green.
  • Motor spins according to the set speed.
  • I2C speed command can be increased now as desired.
  • Click Write to EEPROM under EEPROM Controls to write the configured values into EEPROM.