10 Revision History
Changes from Revision A (May 2025) to Revision B (November 2026)
- Added "When the converter is disabled, the DRV_SUP supply needs to be
disabled such that BTST1/BTST2 and DRV_SUP pins are not biased."Go
- Added Section 7.3.3.4Go
- Updated REG0x22 to include MPPT_STATGo
Changes from Revision * (July 2024) to Revision A (May 2025)
- Changed 5mΩ to 2mΩ in Features sectionGo
- Added ACDRV, SYS, and VAC pin descriptions to Pin Configuration and
Functions sectionGo
- Updated Device Power-Up From Battery Without Input Source
sectionGo
- Added "When the converter is disabled, the DRV_SUP supply needs to be
disabled such that BTST1/BTST2 and DRV_SUP pins are not biased."Go
- Added Section 7.3.3.4Go
- Updated ILIM_HIZ Pin sectionGo
- Changed REG0x26 bit 0 from Reserved to
MPPT_FLAGGo
- Changed REG0x29 bit 0 from Reserved to
MPPT_MASKGo
- Updated REG0x2B bit 7 NotesGo
- Changed title of Figure 8-1Go
- Updated Table 8-1Go
- Changed Equation 10 in Charge Voltage Selection sectionGo
- Updated Sense Resistor (RAC_SNS and RBAT_SNS)
and Current Programming sectionGo
- Updated ACFETs and BATFETs Selection sectionGo
- Updated Application Curves sectionGo