The SPI command box, allow access to the read from and write to registers. In order to ensure connection to the TPS92682-Q1, perform the following steps as shown in Figure 7-6.

1. Write the register address zero in the Register Address box: 0x00.
2. Click Sendtwice.

The default value (0x3C) for the register 0 shows in the SPI Status window.

To write to a register, select the Write check-box. Write the desired data in the Write Data box shown in Figure 7-6. Click Send to write the data to the associated register address.

Figure 7-6 SPI Command Window