SLVUDE3 August   2025

 

  1.   1
  2.   Description
  3.   Get Started
  4.   Features
  5.   Applications
  6.   6
  7. 1Evaluation Module Overview
    1. 1.1 Introduction
    2. 1.2 Kit Contents
    3. 1.3 Specification
    4. 1.4 General Safety Information
    5. 1.5 Hardware
      1. 1.5.1 IO and Jumper Descriptions
  8. 2Software
    1. 2.1 Communication Interface Setup
      1. 2.1.1 BQSTUDIO using EV2400
  9. 3BQ24810 EVM Evaluation
    1. 3.1 Equipment
    2. 3.2 Equipment Setup
    3. 3.3 BQ24810 EVM Test Procedure
      1. 3.3.1 AC Adapter Detection Threshold
      2. 3.3.2 Charger Parameter Settings
      3. 3.3.3 Charge Current and AC Current Regulation (DPM)
      4. 3.3.4 Hybrid Boost Mode
      5. 3.3.5 Battery-only Boost Mode
      6. 3.3.6 Power Path Selection
  10. 4Hardware Design Files
    1. 4.1 Schematic
    2. 4.2 BQ24810EVM PCB Layouts
    3. 4.3 Bill of Materials
  11. 5Additional Information
    1. 5.1 Trademarks

3.3.2 Charger Parameter Settings

In the main software window, click the Refresh button on the top right corner. Make sure there is no error information.

  1. Type “512” (mA) in ChargeCurrent Register and click OK. This sets the battery charge current regulation threshold.
  2. Type “12592” (mV) in ChargeVoltage Register and click OK. This sets the battery voltage regulation threshold.
  3. Measure → V(TP5(BAT)) = 12.6V ±200mV