SNVU932A March   2025  – August 2025 LP5814 , LP5814I , LP5815

 

  1.   1
  2.   Description
  3.   Get Started
  4.   Features
  5.   Applications
  6.   6
  7. 1Evaluation Module Overview
    1. 1.1 Introduction
    2. 1.2 Kit Contents
    3. 1.3 Device Information
  8. 2Hardware
    1. 2.1 Setup
    2. 2.2 Jumper Information
  9. 3Software
    1. 3.1 Software Description
    2. 3.2 Graphical User Interface (GUI) Installation
    3. 3.3 Graphical User Interface (GUI) Guidance
      1. 3.3.1 Hardware Connection
      2. 3.3.2 Start Page
      3. 3.3.3 Hardware Setup Page
      4. 3.3.4 Home Page
      5. 3.3.5 LED Control Page
        1. 3.3.5.1 Turn ON LED in Manual Mode
        2. 3.3.5.2 Turn On LED in Autonomous Mode
      6. 3.3.6 Enter and Exit Shutdown Mode
      7. 3.3.7 Read Flags
  10. 4Hardware Design Files
    1. 4.1 Schematics
    2. 4.2 PCB Layouts
    3. 4.3 Bill of Materials (BOM)
  11. 5Additional Information
    1. 5.1 Trademarks
  12. 6Revision History

1.1 Introduction

The LP5814DRLEVM and LP5814YCHEVM can be converted for testing the LP5816 or the LP5814I by replacing the factory-installed device (U1) with the LP5816 or the LP5814I device.

LP5815DRLEVM and LP5815YCHEVM can be converted for testing the LP5817 by replacing the factory-installed device (U1) with the LP5817 device.

This user's guide describes the LP5814DRLEVM and LP5814YCHEVM and LP5815DRLEVM and LP5815YCHEVM evaluation modules. This user's guide is used as a reference for engineering evaluation. Included in this user's guide are hardware setup instructions, Graphical User Interface (GUI) installation, GUI guidance, schematic diagrams, print board (PCB) layout and bill of materials (BOM).