SBAU358A November   2020  – June 2025 AFE10004

 

  1.   1
  2.   Description
  3.   Get Started
  4.   Features
  5.   Applications
  6.   6
  7. 1Evaluation Module Overview
    1. 1.1 Introduction
    2. 1.2 Kit Contents
    3. 1.3 Specification
    4. 1.4 Device Information
  8. 2Hardware
    1. 2.1 Power Requirements
      1. 2.1.1 Configuring the EVM for a Positive Output Range
      2. 2.1.2 Configuring the EVM for a Negative Output Range
    2. 2.2 Header Information
    3. 2.3 Jumper Information
    4. 2.4 Interfaces
      1. 2.4.1 SPI Configuration
      2. 2.4.2 I2C Configuration
    5. 2.5 Test Points
  9. 3Software
    1. 3.1 Software Installation
    2. 3.2 Software Description
      1. 3.2.1 Launching the Software
      2. 3.2.2 Low Level Configuration Page
      3. 3.2.3 Block Diagram Page
      4. 3.2.4 Look Up Table Page
        1. 3.2.4.1 Loading and Saving LUT Files
  10. 4Hardware Design Files
    1. 4.1 Schematics
    2. 4.2 PCB Layouts
    3. 4.3 Bill of Materials (BOM)
  11. 5Additional Information
    1. 5.1 Electrostatic Discharge Caution
    2. 5.2 Trademarks
  12. 6Related Documentation
  13. 7Revision History

4.2 PCB Layouts

Figure 4-4 through Figure 4-7 show the AFE10004EVM board layout.

AFE10004EVM AFE10004EVM PCB Top Layer Layout Figure 4-4 AFE10004EVM PCB Top Layer Layout
AFE10004EVM AFE10004EVM PCBMid Layer 1 Layout (Ground Plane) Figure 4-5 AFE10004EVM PCBMid Layer 1 Layout (Ground Plane)
AFE10004EVM AFE10004EVM PCB Mid Layer 2 Layout (Power Plane) Figure 4-6 AFE10004EVM PCB Mid Layer 2 Layout (Power Plane)
AFE10004EVM AFE10004EVM PCB Bottom Layer Layout Figure 4-7 AFE10004EVM PCB Bottom Layer Layout