SLUUDA1 April   2025

 

  1.   1
  2.   Description
  3.   Applications
  4.   Features
  5.   5
  6. 1Evaluation Module Overview
    1. 1.1 Introduction
    2. 1.2 Kit Contents
    3. 1.3 Specifications
    4. 1.4 Device Information
  7. 2Hardware
    1. 2.1 Power Requirements
    2. 2.2 Setup
    3. 2.3 Header Information
      1. 2.3.1 USB Interface
      2. 2.3.2 Communication Interfaces
      3. 2.3.3 GPIO Interface (Future Implementation)
    4. 2.4 Jumper Information
      1. 2.4.1 Pull-Up Interface
      2. 2.4.2 1MHz Pull-Up Interface
      3. 2.4.3 MCU Power Headers
    5. 2.5 Push Buttons
    6. 2.6 Interfaces
      1. 2.6.1 Overview
      2. 2.6.2 I2C Interface
      3. 2.6.3 SMBus Interface
      4. 2.6.4 SPI Interface (Future Implementation)
      5. 2.6.5 UART Interface (Future Implementation)
  8. 3Software
    1. 3.1 Software Description
    2. 3.2 Software Installation
    3. 3.3 GUI Installation
    4. 3.4 Software Development
    5. 3.5 Programming Options
  9. 4Hardware Design Files
    1. 4.1 Schematics
    2. 4.2 PCB Layouts
    3. 4.3 Bill of Materials (BOM)
  10. 5Additional Information
    1. 5.1 Trademarks
  11. 6Related Documentation

1.1 Introduction

The EV2500 EVM interface board enables the user to communicate to TI gas gauges using SMBus and I2C interfaces (SPI/UART will be supported in a future update). This allows the user to change configurations, log data, and other features when using in tandem with the Battery Management Studio GUI. The EV2500 is an upgraded version of the previous EV2400 that allows for 1MHz communication speed on I2C and SMBus, different voltage pullup options, and other new features.

This board is intended for evaluation purposes only, and does not support production.