SLVUDJ8 April   2026 TPS61371

 

  1.   1
  2.   Description
  3.   Get Started
  4.   Features
  5.   Applications
  6.   6
  7. 1Evaluation Module Overview
    1. 1.1 Introduction
    2. 1.2 Kit Contents
    3. 1.3 Specification
    4. 1.4 Device Information
  8. 2Hardware
    1. 2.1 Connector and Test Point Descriptions
    2. 2.2 Jumper Configuration
      1. 2.2.1 J5 (ENABLE)
      2. 2.2.2 J6 (MODE)
      3. 2.2.3 J7 (I2C Target Address Selection)
    3. 2.3 Test Procedure
  9. 3Software
    1. 3.1 Software User Interface
      1. 3.1.1 Install USB2ANY Explorer
      2. 3.1.2 GUI Installation
      3. 3.1.3 Interface Hardware Setup
      4. 3.1.4 User Interface Operation
      5. 3.1.5 Register Map Screen
  10. 4Hardware Design Files
    1. 4.1 Schematic
    2. 4.2 PCB Layouts
    3. 4.3 Bill of Materials
  11. 5Additional Information
    1. 5.1 Trademarks

Get Started

  1. Order the EVM on ti.com.
  2. Read the user's guide carefully.
  3. Prepare the bench setup per instructions. Take precautions to prevent damage by ESD when handling the EVM.
  4. Power up the EVM by following the recommended steps.
  5. Run tests and measurements. Take cautions of high voltage and hot temperature produced by the EVM during test.