SBOS258E November   2002  – April 2025 OPA698

PRODUCTION DATA  

  1.   1
  2. 1 Features
  3. 2 Applications
  4. 3 Description
  5. 4 Related Products
  6. 5 Pin Configuration and Functions
  7. 6 Specifications
    1. 6.1 Absolute Maximum Ratings
    2. 6.2 ESD Ratings
    3. 6.3 Recommended Operating Conditions
    4. 6.4 Thermal Information
    5. 6.5 Electrical Characteristics VS = ±5V
    6. 6.6 Electrical Characteristics VS = 5V
    7. 6.7 Typical Characteristics: VS = ±5V
    8. 6.8 Typical Characteristics: VS = 5V
  8. 7 Detailed Description
    1. 7.1 Overview
  9. 8 Application and Implementation
    1. 8.1 Application Information
      1. 8.1.1  Output Limiters
      2. 8.1.2  Output Drive
      3. 8.1.3  Thermal Considerations
      4. 8.1.4  Capacitive Loads
      5. 8.1.5  Frequency Response Compensation
      6. 8.1.6  Pulse Settling Time
      7. 8.1.7  Distortion
      8. 8.1.8  Noise Performance
      9. 8.1.9  DC Accuracy and Offset Control
      10. 8.1.10 Input and ESD Protection
    2. 8.2 Typical Applications
      1. 8.2.1  Wideband Voltage-Limiting Operation
      2. 8.2.2  Single-Supply, Noninverting Amplifier
      3. 8.2.3  Wideband Inverting Operation
      4. 8.2.4  Limited Output, ADC Input Driver
        1. 8.2.4.1 Limited-Output, Differential ADC Input Driver
        2. 8.2.4.2 Precision Half-Wave Rectifier
      5. 8.2.5  High-Speed Full-Wave Rectifier
        1. 8.2.5.1 High-Speed Full-Wave Rectifier #1
        2. 8.2.5.2 High-Speed Full-Wave Rectifier #2
      6. 8.2.6  Soft-Clipping (Compression) Circuit
      7. 8.2.7  Very High-Speed Schmitt Trigger
      8. 8.2.8  Unity-Gain Buffer
      9. 8.2.9  DC Restorer
      10. 8.2.10 Video Sync Stripper
    3. 8.3 Power Supply Recommendations
    4. 8.4 Layout
      1. 8.4.1 Layout Guidelines
  10. 9 Device and Documentation Support
    1. 9.1 Device Support
      1. 9.1.1 Demonstration Fixture
    2. 9.2 Receiving Notification of Documentation Updates
    3. 9.3 Support Resources
    4. 9.4 Trademarks
    5. 9.5 Electrostatic Discharge Caution
    6. 9.6 Glossary
  11. 10Revision History
  12. 11Mechanical, Packaging, and Orderable Information

Typical Characteristics: VS = ±5V

at TA = 25°C, G = 2V/V, RF = 402Ω, RL = 500Ω, and VH = –VL = 2V (unless otherwise noted)

OPA698 Noninverting Small-Signal
                        Frequency Response
VO = 0.2VPP
Figure 6-1 Noninverting Small-Signal Frequency Response
OPA698 Noninverting Large-Signal
                        Frequency Response
 
Figure 6-3 Noninverting Large-Signal Frequency Response
OPA698 VH—Limiter
                        Small-Signal Frequency Response
G = 2V/V VO =20mVPP
Figure 6-5 VH—Limiter Small-Signal Frequency Response
OPA698 Small-Signal Pulse
                        Response
 
Figure 6-7 Small-Signal Pulse Response
OPA698 VH—Limited
                        Pulse Response
 
Figure 6-9 VH—Limited Pulse Response
OPA698 Limited Output
                        Response
 
Figure 6-11 Limited Output Response
OPA698 Harmonic Distortion vs
                        Load Resistance
f = 5MHz VO = 2VPP
Figure 6-13 Harmonic Distortion vs Load Resistance
OPA698 Harmonic Distortion vs
                        Frequency
VPP = 2VPP
Figure 6-15 Harmonic Distortion vs Frequency
OPA698 Harmonic Distortion vs
                        Noninverting Gain
f = 5MHz VPP = 2VPP
Figure 6-17 Harmonic Distortion vs Noninverting Gain
OPA698 Harmonic Distortion Near
                        Limiting Voltages
f = 5MHz VPP = 2VPP
Figure 6-19 Harmonic Distortion Near Limiting Voltages
OPA698 Recommended RS
                        vs Capacitive Load
 
Figure 6-21 Recommended RS vs Capacitive Load
OPA698 Input Voltage and Current
                        Noise Density
 
Figure 6-23 Input Voltage and Current Noise Density
OPA698 Voltage Range vs
                        Temperature
  VH = –VL = 4.3V
Figure 6-25 Voltage Range vs Temperature
OPA698 Limiter Input Bias Current
                        vs Bias Voltage
 
Figure 6-27 Limiter Input Bias Current vs Bias Voltage
OPA698 Common-Mode Rejection
                        Ratio and Power-Supply Rejection vs Frequency
 
Figure 6-29 Common-Mode Rejection Ratio and Power-Supply Rejection vs Frequency
OPA698 Limiter
                        Feedthrough
 
Figure 6-31 Limiter Feedthrough
OPA698 ±PSRR and CMRR vs
                        Temperature
 
Figure 6-33 ±PSRR and CMRR vs Temperature
OPA698 Inverting Small-Signal
                        Frequency Response
VO = 0.2VPP
Figure 6-2 Inverting Small-Signal Frequency Response
OPA698 Inverting Large-Signal
                        Frequency Response
G = –2V/V
Figure 6-4 Inverting Large-Signal Frequency Response
OPA698 VL—Limiter
                        Small-Signal Frequency Response
G = 2V/V VO = 20mVPP
Figure 6-6 VL—Limiter Small-Signal Frequency Response
OPA698 Large-Signal Pulse
                        Response
 
Figure 6-8 Large-Signal Pulse Response
OPA698 VL—Limited
                        Pulse Response (20MHz)
 
Figure 6-10 VL—Limited Pulse Response (20MHz)
OPA698 Detail of Limited Output
                        Voltage
 
Figure 6-12 Detail of Limited Output Voltage
OPA698 5MHz Harmonic Distortion
                        vs Supply Voltage
f = 5MHz VPP = 2VPP
Figure 6-14 5MHz Harmonic Distortion vs Supply Voltage
OPA698 5MHz Harmonic Distortion
                        vs Output Voltage
f = 5MHz VH = VL = VOPP / 2 + 0.5V
Figure 6-16 5MHz Harmonic Distortion vs Output Voltage
OPA698 Harmonic Distortion vs
                        Inverting Gain
f = 5MHz VPP = 2VPP
Figure 6-18 Harmonic Distortion vs Inverting Gain
OPA698 2-Tone, 3rd-Order
                        Intermodulation Intercept
 
Figure 6-20 2-Tone, 3rd-Order Intermodulation Intercept
OPA698 Frequency Response vs
                        Capacitive Load
VO = 0.2VPP
Figure 6-22 Frequency Response vs Capacitive Load
OPA698 Open-Loop Frequency
                        Response
 
Figure 6-24 Open-Loop Frequency Response
OPA698 Limited Voltage Range vs
                        Temperature
  VH and VL open
Figure 6-26 Limited Voltage Range vs Temperature
OPA698 Supply and Output Currents
                        vs Temperature
 
Figure 6-28 Supply and Output Currents vs Temperature
OPA698 Typical DC Drift Over
                        Temperature
 
Figure 6-30 Typical DC Drift Over Temperature
OPA698 Closed-Loop Output
                        Impedance
 
Figure 6-32 Closed-Loop Output Impedance
OPA698 Output Voltage and Current
                        Limitations
 
Figure 6-34 Output Voltage and Current Limitations