SLVSIO7 July 2026 LM5192
PRODUCTION DATA
The LM5192 oscillator is programmed by setting the FREQ bits in the device configuration register MFG_DEVICE_CFG_D1 according to Table 7-4.
| FREQ | SWITCHING FREQUENCY SELECTION |
|---|---|
| 0b00 | 200kHz |
| 0b01 | 400kHz (default) |
| 0b10 | 600kHz |
| 0b11 | 2.2MHz |
Under low VIN conditions when the high-side MOSFETs on-time exceeds the programmed oscillator period, the LM5192 extends the switching period of that channel until the PWM latch is reset by the current sense ramp exceeding the controller compensation voltage. In such an event, the oscillators operate independently and asynchronously until the channel can maintain output regulation at the programmed frequency. Equation 2 calculates the approximate input voltage level below which this phenomenon occurs, where tSW is the switching period and tOFF(min) is the minimum off-time of 80ns.