SLVSJC6 December 2025 TPS544B27W
PRODUCTION DATA
PMBUS_ADDR is shown in Figure 7-73 and described in Table 7-95.
Return to the Summary Table.
Write Transaction: Write Word
Read Transaction: Read Word
Data Format: Unsigned Binary (2 bytes)
NVM Back-up: EEPROM
Updates: On-the-fly. STORE_USER_ALL then power on reset required for the device to respond to a new PMBus address. This command contains bits for setting the PMBus address for the device and other configuration settings for the PMB_ADDR pin.
| 15 | 14 | 13 | 12 | 11 | 10 | 9 | 8 |
| RESERVED | PMB_ADDR[6:0] | ||||||
| R-0h | R/W-Xh | ||||||
| 7 | 6 | 5 | 4 | 3 | 2 | 1 | 0 |
| OVRD_PMB_ADDR | SEL_PMB_DAT_DEL[1:0] | RESERVED | SEL_PSTR_ADDR_BASE[3:0] | ||||
| R/W-Xh | R/W-Xh | R-0h | R/W-Xh | ||||
| Bit | Field | Type | Reset | Description |
|---|---|---|---|---|
| 15 | RESERVED | R | 0h | |
| 14:8 | PMB_ADDR[6:0] | R/W | X | This 7-bit code determines the PMBus address of the part. After power on reset, the value readback from this field are the address the device responds to. Refer to the PMB_ADDR Pinstrap section for details on how pinstrapping affects this field. |
| 7 | OVRD_PMB_ADDR | R/W | X | This bit determines if the PMBus address is from pinstrap or from NVM setting. Setting this bit does not override the selection between option 0 and option 1 described in the PMB_ADDR Pinstrap section. In order for this bit to take effect, the user has to write this bit, store to EEPROM, and power-cycle the part.
|
| 6:5 | SEL_PMB_DAT_DEL[1:0] | R/W | X | This bit field enables the addition of internal delay to the PMBus data input. This delay affects only incoming data and does not delay data out of the device. Adding internal delay may be necessary if a PMBus controller is designed to transition the data line simultaneously with the clock falling edge. Without appropriate delay, differences in fall times between data and clock lines can cause the device to detect the data falling edge before the clock falling edge, incorrectly interpreting it as a START condition. However, excessive delay settings can cause issues with PMBus controllers that transition data lines near the minimum data setup time (50ns for 1 MHz Class). TI does not recommend adding internal delay when using such controllers. These configuration bits take effect immediately after the PMBus transaction completes, without requiring a STORE-RESTORE cycle.
|
| 4 | RESERVED | R | 0h | |
| 3:0 | SEL_PSTR_ADDR_BASE[3:0] | R/W | X | The bit field sets bits 6:3 of the PMBus address set through the PMB_ADDR pinstrap. For changes to take effect, the user must write the new value, store to EEPROM, and power-cycle the device. The new pinstrapped PMBus address becomes active only after a complete power cycle. |