SPRACU8B August   2021  – January 2023 AM68 , AM68 , AM68A , AM68A , AM69 , AM69 , AM69A , AM69A , DRA821U , DRA821U , DRA829V , DRA829V , TDA4VM , TDA4VM

 

  1.   Abstract
  2.   Trademarks
  3. 1Introduction
    1. 1.1 Features
      1. 1.1.1 Supported Features (version 0.10.0)
      2. 1.1.2 Unsupported Features (version 0.10.0)
    2. 1.2 Spreadsheet Overview
      1. 1.2.1 Input Worksheets
      2. 1.2.2 Output Worksheets
      3. 1.2.3 Other Worksheets
    3. 1.3 Default SDK Configurations
  4. 2Customizing DDR Configuration
    1. 2.1 Config Worksheet
      1. 2.1.1 System Configuration
      2. 2.1.2 Memory Burst Configuration
    2. 2.2 DRAMTiming Worksheet
      1. 2.2.1 Latency Parameters
      2. 2.2.2 Non-Latency Parameters
    3. 2.3 IO Control Worksheet
      1. 2.3.1 Determining IO Settings
      2. 2.3.2 Processor/DDR Controller IO
      3. 2.3.3 DRAM I/O
  5. 3Software Considerations
    1. 3.1 Updating U-Boot
      1. 3.1.1 Updating DDR Register Settings
      2. 3.1.2 Updating Source to Set Available Memory Size
    2. 3.2 Updating RTOS PDK
      1. 3.2.1 Updating DDR Register Settings
  6. 4Troubleshoot Guide
    1. 4.1 Topics/Issues
      1. 4.1.1 Topic 1
      2. 4.1.2 Topic 2
      3. 4.1.3 Topic 3
  7. 5References
  8.   Revision History

4.1.3 Topic 3

Issue: When I select any of the push buttons within the workbook, I receive an error message that states "Cannot run the macro ..." (as shown in Figure 4-5).

GUID-DFDF55E7-2C85-4489-A674-700DEF207FEA-low.png Figure 4-5 "Cannot run the macro" Error

Solution: Enable macros for the workbook using the steps listed below and as shown in Figure 4-6:

  1. From the workbook "File" menu, select "Options"
  2. Select "Trust Center"
  3. Select "Trust Center Settings..."
  4. Select "Macro Settings"
  5. Select "Disable all macros with notification"
  6. Save the workbook to ensure any content modified is saved. Close the workbook and then re-open.
  7. When prompted upon re-opening the file, select "Enable Content"

GUID-678FFFD9-8B02-46D2-BDD6-5E83898F8FB0-low.png Figure 4-6 Enabling Workbook Macros

Explanation: Macros may be disabled by default on some computers, and may not provide any option to enable when the file is opened. However, the push buttons rely on macros included with the workbook and thus must be enabled to work properly.