SPRACU8B August   2021  – January 2023 AM68 , AM68 , AM68A , AM68A , AM69 , AM69 , AM69A , AM69A , DRA821U , DRA821U , DRA829V , DRA829V , TDA4VM , TDA4VM

 

  1.   Abstract
  2.   Trademarks
  3. 1Introduction
    1. 1.1 Features
      1. 1.1.1 Supported Features (version 0.10.0)
      2. 1.1.2 Unsupported Features (version 0.10.0)
    2. 1.2 Spreadsheet Overview
      1. 1.2.1 Input Worksheets
      2. 1.2.2 Output Worksheets
      3. 1.2.3 Other Worksheets
    3. 1.3 Default SDK Configurations
  4. 2Customizing DDR Configuration
    1. 2.1 Config Worksheet
      1. 2.1.1 System Configuration
      2. 2.1.2 Memory Burst Configuration
    2. 2.2 DRAMTiming Worksheet
      1. 2.2.1 Latency Parameters
      2. 2.2.2 Non-Latency Parameters
    3. 2.3 IO Control Worksheet
      1. 2.3.1 Determining IO Settings
      2. 2.3.2 Processor/DDR Controller IO
      3. 2.3.3 DRAM I/O
  5. 3Software Considerations
    1. 3.1 Updating U-Boot
      1. 3.1.1 Updating DDR Register Settings
      2. 3.1.2 Updating Source to Set Available Memory Size
    2. 3.2 Updating RTOS PDK
      1. 3.2.1 Updating DDR Register Settings
  6. 4Troubleshoot Guide
    1. 4.1 Topics/Issues
      1. 4.1.1 Topic 1
      2. 4.1.2 Topic 2
      3. 4.1.3 Topic 3
  7. 5References
  8.   Revision History

4.1 Topics/Issues

  1. When I try to save the register output, I receive an error that states "Run-time error '13': Type mismatch". I also observe "#N/A" for some of the register values (as shown in Figure 4-1).
  2. When I change inputs to the worksheets and save the register settings, I notice that the values are the same as they were before (as shown in Figure 4-3).
  3. When I select any of the push buttons within the workbook, I receive an error message that states "Cannot run the macro ..." (as shown in Figure 4-5).